Denon AVR-5308CI Owners Manual - English - Page 82
Setting the Remote ID, Learning Function - av receiver
View all Denon AVR-5308CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Signal transmission indicator [ AMP] [ TU] [ NET/DTU] [SYSTEM CALL] [CHANNEL+/-] [NUMBER] 79 [MODE SELECTOR] [POWER ON] [RC SETUP] [8], [9], [1], [6], [7], [3], [2] Setting the Remote ID When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver operates. 1 Press [AMP] to set the main remote control unit to the AMP mode. 2 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 3 Refer to the table at the right, and use [NUMBER] to input the 5-digit number corresponding to the remote ID to be changed. The signal transmission indicator flashes twice. 4 Press [TU], [iPod] or [NET/DTU] to select the mode to be set. 5 Repeat steps 2 to 4 to set the remote IDs for all modes. MODE SELECTOR AMP (MAIN) Remote ID 1 (Default) 2 3 4 81001 82001 83001 84001 TUNER (Analog TUNER) (XM) 52863 52795 52800 52805 52864 52812 52813 52814 iPod 72815 72816 72817 72818 NET/DTU (Net Audio) 62865 62837 62838 62839 (HD Radio) 62840 62841 62842 62843 Learning Function If your AV devices are of a brand other than DENON or if they cannot be operated with the preset memory function, their remote control signals can be transfered to stored in the AVR5308CI's main remote control unit. 1 Press [MODE SELECTOR] for the device you want to set. 2 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 3 Press [9], [7] and [5], in that order. The signal transmission indicator flashes twice and the learning mode is set. 4 Press the button to be set. The main remote control unit's display turns off. b If a button that cannot be learned is pressed, the signal transmission indicator lights but the signal is not learned. 5 Point the main remote control units directly at each other and press and hold the button on the other device's remote control unit that you want to learn. Once learning is completed normally, the display lights and the signal transmission indicator flashes twice. Other device's remote control unit NOTE • When changing a setting, be sure to set the same remote ID as the AVR-5308CI's (vpage 41). • When changing the AMP mode's remote ID, also change the "TUNER", "iPod" and "NET/DTU" remote ID at the same time. • Set the remote ID of an analog tuner for "TUNER" ( ), the XM remote ID for " ". AVR-5308CI's main remote control unit (RC-1067) b If you want to learn other buttons, repeat steps 4 and 5. b The mode can be switched by pressing [MODE SELECTOR]. b T he signal transmission indicator lights once for a long time if learning was not possible 6 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed.