Denon AVR 888 Owners Manual - English - Page 49

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting ENGLISH Checking the XM Signal Strength and Radio ID 1 Either turn or press [SAT TU] to select "XM". 2 Press STATUS until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display GOOD MARGINAL WEAK NO Status Signal strength is good Signal strength is marginal Signal strength is weak No signal 3 Adjust the position of the antenna until "SIGNAL: GOOD" is shown on the display. 4 Press STATUS until the station you want to check (example: "XM001") is displayed. 5 Press TUNING and select channel 0 (XM000). The radio ID is shown on the display. Radio ID Searching Categories 1 Press o p. Channel category 2 Use o p to select the category, then use ui to select the desired station. Basic Operation 1 Make the necessary preparations. qSet the iPod in the DENON Control Dock for iPod. (vSee the Control Dock for iPod's operating instructions.) wAssign the Control Dock for iPod's input. MENU : "Input Setup" - "Assign" - "iPod dock" (vpage 35) iPod® Playback The music on an iPod can be played by using the Control Dock for iPod (ASD-1R, ASD-3N or ASD-3W, sold separately). The operation can also be performed using the buttons on the main unit or remote control unit while watching the menus. 2 Either turn or press [iPod] to select the input source assigned in step 1-w above. iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. OK to disconnect. (iPod screen) b If the screens above are not displayed, the iPod may not be properly connected. Try connecting again. 3 Set [MODE SELECTOR 1] to "AUDIO" and [MODE SELECTOR 2] to "iPod/NETWORK". (vpage 50 "Remote Control Unit Operations") The strength of both the XM satellite and terrestrial signals can be checked at menu "Input Setup" - "Antenna Aiming" (vpage 36). • With the default settings, the iPod can be used connected to the VCR (iPod) connector. • Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is "Mode3". • Press and set the AVR-888's power to the standby mode before disconnecting the iPod. Also switch the input source to one to which the menu "iPod dock" is not assigned before disconnecting the iPod. NOTE • Depending on the type of iPod and the software version, some functions may not operate. • DENON will accept no responsibility whatsoever for any loss of iPod data. • When using an ASD-3N or ASD-3W Control Dock for iPod, refer to the respective manual to operate.