Denon DCD-CX3 Owners Manual - English - Page 16

Getting Started Connections Operations Troubleshooting Specifications ENGLISH Using the Timer Play Function Also refer to the operating instructions of the audio timer. DCD-CX3 (This unit) Receiver Troubleshooting If a problem should arise, first check the following: 1. Are the connections correct ? 2. Is the set being operated as described in the operating instructions ? 3. Are the other components operating properly ? If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase. Audio timer AC outlet (wall) 1 Turn on the power of the connected components. 2 Switch the receiver's input function to the function to which the player is connected. 3 Load a disc in the player. 4 Set the audio timer for the desired times. 5 Turn the timer "ON". The power of the components connected to the timer turns off. b When the set time is reached, the power of the different components automatically turns on and playback starts from the first track. Symptom Disc tray does not open. Cause • The power is not on. Measures • Turn on the power. "NO DISC" is displayed even • The disc is not properly loaded. • Reload the disc. though a disc is loaded. "00 : 00" is displayed even • A disc other than a CD or Super Audio CD • Load a CD or Super Audio CD. though a disc is loaded. is loaded. Playback does not start even when • The disc is dirty or scratched. the 1/3 button on the main unit or the 1 button on the remote • Wipe the dirt off the disc or replace the disc. control unit is pressed. No sound is produced or sound is • The output cables are not properly • Check the connections. distorted. connected to the receiver. • The receiver's function setting or • Check the receiver's function and controls adjustments are not right. and adjust as necessary. No digital signals are output. • For Super Audio CDs, no digital signals • For Super Audio CDs, use the analog audio are output. output signals. • Turn the pure direct mode on. • Turn the pure direct mode off. A specific section of the disc • The disc is dirty or scratched. • Wipe the dirt off the disc or replace the cannot be played properly. disc. Programmed playback is not • The tracks have not been programmed • Program properly. possible. properly. A CD-R or CD-RW disc cannot be • The disc has not been finalized. • Finalize the disc then play it. played. • The recording conditions are bad or the • Use a properly recorded disc. quality of the disc itself is poor. Files recorded in MP3 or WMA format cannot be played. • You have selected a copyright-protected • P ress the 8 or 9 button to select a WMA file or a file that cannot be played different file. normally. Set does not operate properly • The batteries are spent. • Replace the batteries with new ones. when remote control unit is • The remote control unit is too far from the • Move the remote control unit closer to the operated. set. set. Page 8 3 3 3 7 - 7 9 3 9, 10 2 2 11 4 4 13