Denon DHT590BA Owners Manual - English - Page 49
Operating the Connected Devices by Remote Control Unit - model
UPC - 883795001120
View all Denon DHT590BA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Operating the Connected Devices by Remote Control Unit Registering Preset Codes DENON and other makes of components can be operated by setting the preset memory. n Cautions during operation When registering a preset code, point the remote control transmitter toward the AVR-590. The status of the registration operation is displayed on the AVR-590. 1 Press the source select button (see below) for the device to be registered and simultaneously for over 2 seconds. "RC SETUP START" appears on the display and the remote control unit is set to the preset code registration mode. : TV : DVD player or CD player : Blu-ray disc player : Digital video recorder : Video deck : Satellite or cable receiver TV 2 Press ~ and input the 3-digit number of the brand of the component to be preset. The numbers are shown in the Preset Code Table (vEnd of this manual). When registration is completed, "RC SETUP OK" appears on the display. b If the codes could not be registered, "RC SETUP NG" appears on the display. Try again. Operating Registered Devices 1 Switch to the device to be operated. TUNER/AMP : To operate a Tuner DEVICE MAIN/TV : To operate a Blu-ray disc player, DVD player, CD player, Digital video recorder, Video deck, iPod, Satellite receiver or cable TV : To operate a TV 2 When "DEVICE" has been selected in step 1, press the source select button for the device to be operated. The remote control unit is set to the device mode for the device to be operated. When the remote control transmitter is pointed towards the AVR-590 at this time, the AVR-590's input source switches simultaneously. b The remote control unit stays in the same device mode until a different source select button is pressed. 3 Operate the component. b For details, refer to the component's operating instructions. NOTE Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes. iPod 3 To store the codes of another component in the memory, repeat steps 1 to 2. b For details, refer to the component's operating instructions. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation. • The preset memory can be set for one component only among the following: DVD/CD and SAT/CBL. ENGLISH Operating Registered Devices Operation mode setting ON/SOURCE 1 2 3 MEMORY TOP MENU 6 7 Power on / Standby z1 Play / Pause Stop Pause MEMORY z1 Calling out the top menus z1 Manual search (fast-reverse / fast-forward) 8 9 uio p ENTER SEARCH RETURN PAGE d f Auto search (cue) Cursor Enter Press and hold Once Browse/Remote mode switching Page search mode switching z2 Return Page up/down z1 z1 : This operation is possible when using a DENON ASD-3N or ASD-3W Control Dock for iPod. z2 : This operation is possible when using a DENON ASD-1R or ASD-11R Control Dock for iPod. 46 Getting Started Connections Settings Playback Remote Control Information Troubleshooting Specifications