Denon DVD 1600 Owners Manual - Page 4

ENGLISH Connection to a television Although the audio on most DVDs is designed to be played through six speakers and this unit's factory settings assume this setup, the following describes connections that allow you to enjoy sound through your television's speakers. To get the full benefit from the powerful 5.1-channel audio found on DVDs, you should connect an amplifier and six speakers (➡ page 16). Before connection ≥Disconnect the AC mains lead. ≥Refer to the television's operating instructions. AUDIO IN L R VIDEO IN Connection to AUDIO IN also necessary (see left) S VIDEO IN SCART VCR red white yellow Audio/video cable (included) S video cable (not included) 21-pin SCART cable (not included) red white yellow 5.1ch AUDIO OUT 2ch AUDIO OUT CENTER SURROUND FRONT DIGITAL OUT L L L VIDEO S-VIDEO OUT OUT AV1 (PCM/BITSTREAM) OPTICAL AV2 SUBWOOFER R R R AC IN AC mains lead (included) S VIDEO OUT terminal The S-video terminal achieves a more vivid picture than the VIDEO OUT terminal by separating the chrominance (C) and luminance (Y) signals. (Actual results depend on the television.) Connect Your Unit Directly To Your Television. Do not connect the unit through your video cassette recorder when setting up your home entertainment system, because the picture may not be played correctly due to the copy guard. SCART terminal ≥To improve picture quality, you can change the video signal output from the AV1 terminal from "Video" to either "S-Video" or "RGB" to suit the type of television you are using (➡ page 18, Video-AV1 Output). ≥You can also connect other equipment to AV2. This unit Video cassette recorder Satellite receiver or decoder SCART terminal AV1 AV1 VCR of television AV2 AV2 TV 4