Dewalt D25892K Instruction Manual - Page 8
Tool Tag Ready Fig. A, Electronic Speed and Impact Control, Fig. A, Mode Selection Fig. E,
View all Dewalt D25892K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English SHOCKS Active Vibration Control® System For best vibration control, hold the tool as described in Proper Hand Position and apply just enough pressure so the damping device on the main handle is approximately mid stroke. The hammer only needs enough pressure to engage the active vibration control. Applying too much pressure will not make the tool chip faster and active vibration control will not engage. DeWALT Tool Tag Ready (Fig. A) Optional Accessory Your hammer comes with mounting holes 9 and fasteners for installing a DeWALT Tool Tag. You will need a T15 bit tip to install the tag. Only use the screws provided. The DeWALT Tool Tag is designed for tracking and locating professional power tools, equipment, and machines using the DeWALT Tool Connect™ app. For proper installation and use of the DeWALT Tool Tag refer to the DeWALT Tool Tag manual. Electronic Speed and Impact Control (Fig. A) The electronic speed and impact control allows the use of smaller chisels without the risk of chisel breakage, chipping into light and brittle materials without shattering and optimal tool control for precise chiseling. To set the speed dial 8 , turn the dial to the desired level. The higher the number, the greater the speed and impact energy. Dial settings make the tool extremely flexible and adaptable for many different applications. The required setting depends on the chisel size and hardness of material being chipped. Mode Selection (Fig. E) WARNING: Do not select the operating mode when the tool is running. Tool must come to a complete stop before activating the mode selector button or damage to the tool may result. Your tool is equipped with a mode selector dial 4 to select the mode appropriate to desired operation. Symbol Mode Application Chisel Chisel position Adjustment adjustment Chipping Light chipping, chiseling and demolition To select a mode • Rotate the mode selector dial 4 so that the arrow points to the symbol corresponding for the desired mode. 6 Fig. E 4 NOTE: The arrow on the mode selector dial 4 must be pointing at a mode symbol at all times. There are no operable positions in between. Performing an Application (Fig. F) WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, ALWAYS ensure workpiece is anchored or clamped firmly. NOTE: Operating temperature of this tool is 19 ˚ to 104 ˚F (-7 ˚ to +40 ˚C). Using the tool outside of this temperature range will decrease the life of the tool. 1. Insert the appropriate chisel and rotate it by hand to lock it into the desired position. Refer to Chisel and Chisel Holder. 2. Using the mode selector dial 4 , select chipping mode . Refer to Mode Selection. 3. Adjust the side handle 2 as necessary. Fig. F 4 1 2 4. Place the chisel on the desired location. 5. Depress the rocker switch 1 . 6. To stop the hammer, release the switch. MAINTENANCE WARNING: To reduce the risk of serious personal injury, turn unit off and disconnect it from power source before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. Cleaning WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened