Dewalt D28710 Instruction Manual - Page 8

English Standard Equipment 1 14" (355mm) metal cutting abrasive wheel 1 Wheel wrench 1 Instruction manual To Carry (Fig. 1) Fold down unit to position where you can carry the saw. Use the chain lock (A) to lock arm down. Unlocking (Fig. 1) To unlock tool and raise head, depress motor arm slightly and unlock the chain lock (A). Motor arm will then pivot upward. Material Clamping and Supporting • Angles are best clamped and cut with both legs resting against base. • A spacer block slightly narrower than the workpiece can be used to increase wheel utilization (Fig. 2). • Long workpieces must be supported by a block so it will be level with top of base (Fig. 3). The cut-off end should be free to fall downward to avoid wheel binding. FIG. 2 DIAMETER OF WORKPIECE E SPACER BLOCK F FIG. 3 CUT-OFF END BLOCK Spark Deflector Adjustment (Fig. 1) To best deflect sparks away from surrounding persons and materials, loosen the screw (B), adjust the spark deflector (C) and then retighten screw. Do not allow cordset to come into contact with deflector or sparks as damage to cordset may occur. FIG. 4 QE FORWARD F I H WIDTH OF SPACER BLOCK 6