Dewalt DC608B Instruction Manual - Page 11
Warning: To Reduce The Risk Of Serious Personal Injury, Always, Before All Repairs
View all Dewalt DC608B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English TROUBLESHOOTING GUIDE MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A DEWALT SERVICE CENTER OR CALL 1-(800)-4-DEWALT. WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, ALWAYS DISCONNECT BATTERY PACK FROM TOOL BEFORE ALL REPAIRS SYMPTOM CAUSE FIX Tool doesn't turn on Tool internal electronics not reset Remove battery, wait 3 seconds and reinsert (Headlights don't turn on) Low battery charge or damaged battery Charge or replace battery Terminals are dirty or damaged See authorized service center Contact trip lock is in a locked position Unlock contact trip lock Bent contact trip See authorized service center Damaged internal electronics See authorized service center Tool doesn't actuate Motor stops running after 2 seconds Normal operation; release trigger or contact trip and redepress (Headlights on, motor does not run) Contact trip or trigger not depressed See instruction manual Damaged trigger See authorized service center Bent contact trip See authorized service center Contact trip lock in the locked position (Sequential mode only) Unlock contact trip lock Damaged internal electronics See authorized service center Tool doesn't actuate (Headlights flash 4 times) Low battery charge or damaged battery Charge or replace battery Tool doesn't actuate (Headlights flash continuously) Jammed fastener Remove the battery, clear the jammed fastener, (push driver blade back up manually if necessary) and reinsert battery pack Jammed mechanism See authorized service center Tool doesn't actuate (Headlights on, motor runs) Damaged internal electronics See authorized service center Tool doesn't actuate Damaged return system Replace return system; see authorized service center (Headlights on, motor runs, driver blade stuck down) Debris in nosepiece Clean nosepiece Damaged driver/return assembly Replace driver/return assembly; see authorized service center Tool operates, but does not drive the fastener fully Low battery charge or damaged battery Charge or replace battery Depth adjustment set too shallow Rotate depth adjustment wheel to a deeper setting Tool not firmly applied to workpiece See instruction manual Material and fastener length too rigorous an application Choose appropriate material or fastener length Damaged or worn driver blade tip Replace driver/return assembly; see authorized service center Damaged or worn driver/return assembly Replace driver/return assembly; see authorized service center Tool operates, but no fastener driven No fasteners in magazine Load fasteners into magazine Wrong size or angle fasteners Use only recommended fasteners Debris in nosepiece Clean nosepiece Debris in magazine Clean magazine Worn magazine Replace magazine; see authorized service center Damaged or worn driver blade Replace driver/return assembly; see authorized service center Damaged pusher spring Replace spring; see authorized service center Jammed fastener Wrong size or angle fasteners Use only recommended fasteners Damaged or worn driver blade Replace driver/return assembly; see authorized service center Material and fastener length too rigorous an application Material or fastener length inappropriate Low battery charge or damaged battery Charge or replace battery Debris in nosepiece Clean nosepiece Debris in magazine Clean magazine Worn magazine Replace magazine; see authorized service center Worn or damaged pusher spring Replace spring; see authorized service center 11