Dewalt DCD791D2 Instruction Manual - Page 13
Worklight Fig. 3, Keyless Single Sleeve Chuck Fig. 4-6 - lowes
View all Dewalt DCD791D2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English 2. To select speed 2 (low torque setting), turn the tool off and permit it to stop. Slide the gear shifter back (away from the chuck). NOTE: Do not change gears when the tool is running. Always allow the drill to come to a complete stop before changing gears. If you are having trouble changing gears, make sure that the dual range gear shifter is either completely pushed forward or completely pushed back. Worklight (Fig. 3) The worklight (E) and its switch (L) are located on the foot of the tool. The worklight is activated when the trigger switch is depressed. The low (M), medium (N) and spotlight (O) modes can be changed by moving the switch on the foot of the tool. If the trigger switch remains depressed, the worklight will remain on in all modes. When on low (M) and medium (N) settings, the beam will automatically turn off 20 seconds after the trigger switch is released. FIG. 3 WARNING: While using the worklight in medium or spotlight mode, do not stare at the light or place the drill in a position which may cause anyone to stare into the light. Serious eye injury could result. CAUTION: When using the tool as a spotlight, be sure it is secured on a stable surface where it will not cause a tripping or falling hazard. CAUTION: Remove all accessories from the chuck before using the drill as a spotlight. Personal injury or property damage could result. LOW BATTERY WARNING When in spotlight mode and the battery is nearing complete discharge, the spotlight will flash twice and then dim. After two minutes, the battery will be completely discharged and the drill will immediately shut down. At this point, replace with a fresh battery. WARNING: To reduce the risk of injury, always have a back-up battery or secondary lighting available if the situation warrants it. E Keyless Single Sleeve Chuck (Fig. 4-6) WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping the front part of the chuck and turning the M tool on. Damage to the chuck and personal injury may result. Always N O lock off trigger switch and disconnect tool from power source when changing accessories. L WARNING: Always ensure the bit is secure before starting the tool. A loose bit may eject from tool causing possible personal injury. Your tool features a keyless chuck (F) with one rotating sleeve for one- SPOTLIGHT MODE The high setting is the spotlight mode (O). The spotlight will run for 20 minutes after the trigger switch is released. Two minutes before the spotlight will shut off, it will flash twice and then dim. To avoid the spotlight shutting off, lightly tap the trigger switch. handed operation of the chuck. To insert a drill bit or other accessory, follow these steps. 1. Turn tool off and disconnect tool from power source. 2. Grasp the black sleeve of the chuck with one hand and use the other hand to secure the tool. Rotate the sleeve counterclockwise far enough to accept the desired accessory. 11