Dewalt DCS372KA Instruction Manual - Page 15
Switch Fig. 2, Changing Blades Fig. 1, 4-6
View all Dewalt DCS372KA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Switch (Fig. 2) The saw is controlled by a trigger switch (A) and lock off button (B). The lock off button must be pressed before the trigger switch will turn the saw on. Releasing the trigger turns the saw off. NOTE: This tool has no provision to lock the switch on. The saw should never be locked on by any means. Changing Blades (Fig. 1, 4-6) WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury. TO INSTALL THE BLADE FIG. 4 1. Place inner clamp washer (O) on saw spindle with the large flat surface D facing out toward the blade (Fig. 4, 5). 2. Retract the lower blade P F guard (G) and place blade on saw spindle against the inner clamp washer O (O), making sure that the blade will rotate in the proper direction (the direction of the rotation arrow on the saw blade and the teeth must point in the same direction as the direction of rotation arrow on the saw). Do not assume that the printing on the blade will always be facing you when properly installed. When retracting the lower blade guard to install the blade, check the condition and operation of the lower blade guard to assure that it is working properly. Make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. FIG. 5 SPINDLE O O P BLADE 13 F P F English