Dewalt DCST922P1 Instruction Manual - Page 10

English the pole completely until the guard 9 securely locks into place over the rear of the battery housing 11 . Fig. B 7 6 8 20 Fig. D Attaching the Auxiliary Handle (Fig. A, C) 1. Place the auxiliary handle 4 on top of the handle base 23 so the upper trimmer pole 15 is between them. 2. Hold the auxiliary handle in place and slide the handle bolts 24 into the handle from the top, threading them into the handle base. 3. Tighten the handle bolts with the supplied hex wrench . Ensure the handle is securely attached. Fig. C 24 24 5 Fig. E 21 9 OPERATION 23 4 Attaching Guard (Fig. D, E) WARNING: Never remove the guard. Damage or personal injury could result. WARNING: NEVER OPERATE APPLIANCE WITHOUT GUARD FIRMLY IN PLACE. The guard must always be properly attached on the appliance to protect the user. 1. Assemble the guard 9 to the motor housing 5 . 2. Using a crosshead screwdriver, insert the 2 guard screws 21 and tighten securely. NOTE: An extended coverage guard is available (sold separately) for extra coverage if desired. Use replacement guard Part Number N776035. WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. Installing and Removing the Battery Pack (Fig. F) NOTE: For best results, make sure your battery pack is fully charged. To install the battery pack 12 into the tool handle, align the battery pack with the rails inside the tool's handle and slide it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage. To remove the battery pack from the tool, press the release button 13 and firmly pull the battery pack out of the tool handle. Insert it into the charger as described in the charger section of this manual 8