Dewalt DWE43114N Instruction Manual - Page 11
Mounting Sanding Backing Pads Fig. G, Mounting and Removing Hubbed, Wheels Fig. A, Mounting Wire Cup
View all Dewalt DWE43114N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
the spindle so that the raised section (pilot) fits into the center of the wheel. If the wheel you are installing is 1/8" (3.17 mm) thick or less, place the threaded locking flange on the spindle so that the raised section (pilot) is not against the wheel. Fig. E Over 1/8" (3.17 mm) wheels 1/8" Or less (3.17 mm) wheels English 4. Tighten the clamp nut by hand. Then depress the spindle lock button while turning the sanding disc until the sanding disc and clamp nut are snug. 5. To remove the wheel, grasp and turn the backing pad and sanding pad while depressing the spindle lock button. Fig. G 21 Locking flange Locking flange 20 Backing Flange Backing Flange 5. While depressing the spindle lock button, tighten the threaded locking flange 4 : -- Tighten the threaded locking flange using a wrench 18 . 6. To remove the wheel, depress the spindle lock button and loosen the threaded locking flange. Fig. F 18 4 17 3 1 Mounting Sanding Backing Pads (Fig. G) NOTE: Use of a guard with sanding discs that use backing pads, often called fiber resin discs, is not required. Since a guard is not required for these accessories, the guard may or may not fit correctly if used. WARNING: Failure to properly seat the clamp nut and/or pad could result in serious injury (or damage to the tool or wheel). WARNING: Proper guard must be reinstalled for grinding wheel, cutting wheel, sanding flap disc, wire brush or wire wheel applications after sanding applications are complete. 1. Place or appropriately thread backing pad 19 on the spindle. 2. Place the sanding disc 20 on the backing pad 19 . 3. While depressing spindle lock button 2 , thread the sanding clamp nut 21 on spindle, piloting the raised hub on the clamp nut into the center of sanding disc and backing pad. 19 Mounting and Removing Hubbed Wheels (Fig. A) Hubbed wheels install directly on the spindle. Thread of accessory must match thread of spindle. 1. Remove backing flange by pulling away from tool. 2. Thread the wheel on the spindle 1 by hand. 3. Depress the spindle lock button 2 and use a wrench to tighten the hub of the wheel. 4. Reverse the above procedure to remove the wheel. NOTICE: Failure to properly seat the wheel before turning the tool on may result in damage to the tool or the wheel. Mounting Wire Cup Brushes and Wire Wheels (Fig. A) WARNING: Failure to properly seat the brush/wheel could result in serious injury (or damage to the tool or wheel). CAUTION: To reduce the risk of personal injury, wear work gloves when handling wire brushes and wheels. They can become sharp. CAUTION: To reduce the risk of damage to the tool, wheel or brush must not touch guard when mounted or while in use. Undetectable damage could occur to the accessory, causing wires to fragment from accessory wheel or cup. Wire cup brushes or wire wheels install directly on the threaded spindle without the use of flanges. Use only wire brushes or wheels provided with a threaded hub. These accessories are available at extra cost from your local dealer or authorised service center. 1. Place the tool on a table, guard up. 9