Dewalt DWFP72155 Instruction Manual - Page 7

English • Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: Tool Specifications MODEL DWFP72155 DESCRIPTION 15 GA "DA" Style Angled Finish Nailer ENGINE TYPE Oil-Free OPERATION PRESSURE RANGE 70-120 psi (4.9 - 8.43 kg/cm2) MAXIMUM OPERATION PRESSURE 120 psi (8.43 kg/cm2) • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety AIR CONSUMPTION AT A RATE OF 60 FASTENERS 1.8 cfm @ 80 psi (5.6 kg/cm2) PER MINUTE * FASTENER TYPE DA Style FASTENER GAUGE 15 Gauge FASTENER RANGE 1-1/4"-2-1/2" (31 mm - 63 mm) MAGAZINE CAPACITY Up to 100 Nails equipment, such as those dust masks that are specially designed to LENGTH 12.8" (325 mm) filter out microscopic particles. WIDTH 3.8" (97 mm) WARNING: ALWAYS USE SAFETY GLASSES. Everyday HEIGHT 12.1" (307 mm) eyeglasses are NOT safety glasses. Also use face or dust mask WEIGHT 4.22 lbs (1.9 kg) if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT: • ANSI Z87.1 eye protection (CAN/CSA/Z94.3), • ANSI S12.6 (S3.19) hearing protection, • NIOSH/OSHA/MSHA respiratory protection. * The DWFP72155 requires 1.8 cubic feet per minute or cfm (51.0 liters per minute or lt/min) of free air at 80 PSI (5.6 kg/cm2) to operate at a rate of 60 fasteners per minute. To determine the appropriately sized air compressor, take the actual rate at which the tool will be run and compare the required C.F.M. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE (LT/MIN) to the compressors free air delivery (cfm/ lt/min) at 80 psi (5.6 kg/cm2). For example, if your fastener usage averages 30 fasteners per minute, you need 50% of the tools cfm required to operate the tool at the rate of 60 fasteners per minute. In this case, be sure that your air compressor can deliver a minimum of 0.9 c.f.m. (25.5 lt/min) at 80 psi (5.6 kg/cm2) for optimum performance of the DWFP72155. 5