Dewalt DXPW60606 Instruction Manual - Page 11

English Tools required (Not included): 1/2" (13 mm) open-end wrench 1/2" (13 mm) socket or 1/2" (13 mm) wrench Hardware (Included with your machine): 1 Handle (F) 1 Leg Assembly (DD) 4 Bolts (EE) 8 Flat Washers (FF) 4 Nuts (GG) 1. Remember to secure/support the machine before removing or loosening the bolts. Use the wrench and socket to remove the leg assembly bolts (EE, GG). 2. Position/slide the handle (O) into the frame (F) and on the outside of each side of the foot bracket assembly (DD). 3. Align the holes in the Handle with the mounting holes in the frame and leg assemblies. 4. Fasten the handle (O) to the foot bracket (DD) and frame (F) with the hardware (EE, FF, GG) from step 1 as shown and tighten each nut until snug. ff eE ff eE gg F ff o ff gg dd 5. Attach high-pressure hose (P) to spray gun. Make sure it is secure. 6. Connect wand (E) to spray gun. Make sure p connection is secure. e 7. Place the grommets (B) onto the panel assembly (A) and push into place. B A 8. Remove the five colored quick-connect nozzles from the plastic bag and insert them into correct grommet on the nozzle holder. Nozzles are color coded to match colored nozzles on panel assembly. NOTE: The high-pressure pump was filled with oil at the factory. Always check oil level before using (refer to Maintenance for more information). Warning: Risk of bursting. Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see the tire sidewall for the correct tire pressure. NOTE: Air tanks, compressors and similar equipment used to inflate tires can fill small tires similar to these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pressure. Add air in small increments and frequently use the tire gauge to prevent over inflation. 9. The pressure washer is now ready for handling. Make sure to follow the Owner's Manual instructions before starting the pressure washer. 11