Dirt Devil ND40015 Revision 1 (6/2010) - Page 15

ASSEMBLY WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. NOTE: All water inlets are covered by a plastic cap that must be removed before installing hoses onto the pressure washer. installing THE DETERGENT TANK and HOLDER See Figure 4. Position the groove on the detergent tank holder over the rib on the side of the pressure washer. Push down on the holder until it locks into place. To install the detergent tank, place the tank in the holder and place the cap and tube onto the tank. Push the cap over the neck of the tank and make certain it is installed securely. installing THE spray wand HOLDER See Figure 5. Position the groove on the spray wand holder over the rib on the side of the pressure washer. Push down on the holder until it locks into place. installing/REMOVING spray WANDS See Figure 6. There are 3 spray wands included with the pressure washer. The variable fan spray wand produces a flat spray and has a low-to-high pressure adjustment. The turbo spray wand produces a pencil jet spray for higher intensity cleaning. The rotary tool has a watergenerated rotary brush, that can be used for a variety of uses. To install spray wand n Push the end of the spray wand into the trigger handle and rotate clockwise to secure. n Pull on the spray wand to be certain it is properly secured. To remove spray wand: n Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure. n Push in on the spray wand and rotate clockwise to remove. connecting high pressure hose to TRIGGER HANDLE See Figure 7. n Place the hex nut over the hose inlet on the trigger handle. n Using a wrench, securely tighten the hex nut. n Pull on the hose to be certain it is properly secured. connecting high pressure extension hose to HOSE REEL* (*In select models only) See Figure 8. n Place the L-shaped coupler end of the extension hose over the water outlet on the front of the pressure washer. n Securely tighten the collar. n Place the other end of the extension hose over the water inlet on the hose reel. n Securely tighten the collar. n Pull on each hose connection to be certain it is properly se- cured. connecting the garden hose See Figure 9. Caution: Always observe all local regulations when connecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water supply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted. The water supply must come from a water main. NEVER use hot water or water from pools, lakes, etc. Before connecting the garden hose: n Uncoil the garden hose. NOTE: There must be a minimum of 10 feet of unrestricted garden hose between the water intake and the garden hose faucet or shut off valve (such as a "Y" shut off connector). n Run water through the garden hose for 30 seconds to clean any debris from the hose. n Inspect the screen in the water intake. n If the screen is damaged, do not use the machine until the screen has been replaced. n If the screen is dirty, clean it before connecting the garden hose to the machine. n With the hose faucet turned completely off, attach the metal coupler to the water inlet and turn clockwise to securely tighten. n Attach the garden hose to the metal coupler and tighten by hand. 8