Dynex DX-24L150A11 Quick Setup Guide (English) - Page 1

24" LCD TV QUICK SETUP GUIDE DX-24L150A11 Remote control and 2 AAA batteries AC power cord Component video cable Front and side features + - Connecting a DVD or Blu-ray DVD player, cable box, satellite receiver or game station Using HDMI (best) Back of TV Installing the stand 1 Remove the stand from the box and place it on a table or bench. Note: Pay close attention to the direction of the stand. The wide portion of the stand must face the front of the TV. 2 Lay the TV on a flat, cushioned surface. 3 Align the stand with the TV, as shown. 4 Move the stand gently until the locators on the stand column align with the locating grooves on the stand. 5 Align the holes in the stand with the holes in the stand column. HDMI device Using component (better) Back of TV HDMI cable (not included) TV stand and screws Quick Setup Guide 6 Secure the stand to the column with the three screws provided Screw holes Component video cable Component video device Using composite (good) Installing a wall-mount bracket 1 Carefully place your TV screen face-down on a cushioned, clean surface to protect the screen from damages and scratches. 2 Remove the four screws holding the TV to its stand column, then remove the stand column. 3 Secure the wall-mount bracket (not included) to the back of your TV using the screws provided with the bracket. Setting up your remote control 1 While pressing the release button on the battery compartment cover on the back of the remote, lift the cover off the remote. 2 Insert two AAA batteries into the battery compartment. Make sure that the + and - symbols on the batteries align with the + and - symbols in the battery compartment. 3 Replace the cover. To program your existing remote control to work with your Dynex TV, see the table below for common codes. If you have problems programming your remote, or need a different remote control code, visit www.dynexproducts.com for the latest remote control code information. Universal remote control TV codes (for all Dynex TVs manufactured after Jan. 1, 2007) Universal remote control makers and models Philips PHDVD5, PH5DSS, PMDVR8, PDVR8 RCA RCU807 One for All URC-6690 Sony RM-VL600 115 135 0464 8043 Comcast M1057 0463 Set-top box makers and models Dish Network VIP508, VIP622 Motorola DRC800 TIVO Series 3, HD 720 0463 0091 DirectTV RC23 10463 Video device N Back of TV Composite video cable Using S-video (fair) Back of TV Video device N S-video cable Connecting an antenna Connect a 75 ohm cable (not included) to ANT/CABLE IN jack on the back of your TV and the RF OUT jack on the antenna. Back of TV Antenna cable Connecting a home theater system Using analog audio cable: Back of TV Audio cable Note: Cable connectors and jacks are often color-coded. Match the colors when you connect the AV cable. Using digital audio cable: Back of TV Note: The DIGITAL OUTPUT jack only works with digital TV channels.