Dynex DX-26LD150A11 Quick Setup Guide (English) - Page 1

26"/32" LCD TV / DVD combo QUICK SETUP GUIDE DX-26LD150A11/DX-32LD150A11 TV DVD INPUT GUIDE 1 23 456 789 0 RECALL MTS/SAP CCD PICTURE AUDIO ZOOM TV MENU FAVORITE EXIT OK ENTER INFO TITLE MENU SETUP A-B REPEAT AUDIO SUBTITLE RETURN Disc label towards front Front and side features MENU INPUT VOL VOL CH CH Remote control Power sensor indicator Installing the stand 1 Remove the stand from the box and place it on a table or bench. 2 Secure the stand column to the stand with the four screws with washers provided. 3 Lay your TV/DVD combo face down on a soft, dry, and lint free surface. Align the bottom side of the TV/DVD combo with one edge of the table. 4 Slide the stand column into the slot in the bottom of the TV/DVD combo. 5 For DX-26LD150A11, secure the stand column to the TV/DVD combo with the ve screws and washers provided. For DX-32LD150A11, secure the stand column to the TV/DVD combo with the eight screws and washers provided, then secure the stand cover to the TV/DVD combo with the two screws provided. Remote AC power control and 2 cord AAA batteries L/R Audio cable DX-26LD150A11 Component video cable Connecting a DVD or Blu-ray DVD player, cable box, satellite receiver, or game station Using HDMI (best) Back of TV / DVD combo Using component (better) HDMI cable (not included) HDMI device Back of TV / DVD combo TV stand column TV stand 9 M4 screws with washers DX-32LD150A11 TV stand column 12 M4 screws with washers Installing a wall-mount bracket 1 Carefully place your TV screen face-down on a cushioned at, clean surface to protect the screen from damages and scratches. 2 Remove the screws holding the TV to its stand column, then remove the stand column. 3 Secure the wall-mount bracket to the back of your TV by using the screws provided with the wall mount. TV stand 2 M3 screws TV stand cover Setting up your remote control 1 While pressing the release button on the battery compartment cover on the back of the remote, lift the cover o the remote. Quick Setup Guide 2 Insert two AAA batteries into the battery compartment. Make sure that the + and - symbols on the batteries align with the + and - symbols in the battery compartment. 3 Replace the cover. To program your existing universal remote control to work with your new Dynex TV, see the table below for common codes. If you have problems programming your remote or need a di erent remote control code, visit www.dynexproducts.com for the latest remote . Universal remote control TV codes (for all Dynex TVs manufactured after Jan. 1, 2007) Universal remote control makers and models Philips PHDVD5, PH5DSS, PMDVR8, PDVR8 RCA RCU807 One for All URC-6690 Sony RM-VL600 Comcast M1057 Set-top box makers and models Dish Network VIP508, VIP622 Motorola DRC800 TIVO Series 3, HD 115 135 0464 8043 0463 720 0463 0091 DirectTV RC23 10463 Component video device Component video cable Audio Cable Using S-video (fair) Back of TV / DVD combo Video device S-video cable Connecting an antenna Connect a 75 ohm cable (not included) to the ANT/CABLE IN jack on the back of the TV/DVD combo, then connect the other end of the cable to the antenna, cable TV or satellite TV box jack. Back of TV / DVD combo Connecting a home theater system Using analog audio cable: Back of TV / DVD combo AUDIO IN Audio Cable Note: Cable connectors and jacks are often color-coded. Connecting a Computer Back of TV / DVD combo VGA Cable Audio Cable