Dynex DX-CVS4 User Manual (English) - Page 9
Maintaining - switch
View all Dynex DX-CVS4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Maintaining 9 Programming the component video selector You can program the component video selector to switch to the correct input when the connected device is powered on with the remote control that came with that device (or a universal remote control that has been programmed to operate the device). To program the component video selector: 1 Make sure that you have connected the component video devices and that you have connected the AC adapter and plugged it into a power outlet. 2 Turn on the connected component video devices. 3 Press and hold the SELECT/LEARN for four seconds. When the LED labeled 1 flashes release the button. 4 Within eight seconds, point the remote control that came with the device connected to the IN1 jacks at the remote control sensor on the front of the component video selector, then press the power button on the remote control. The LED and the connected device turn off. If you do not press a button on the remote control within eight seconds of pressing the SELECT/LEARN button, the component video selector exits learning mode. 5 Repeat Step 4 using the remote controls that came with the devices connected to the other IN jacks. For example, use the remote control that came with the device connected to the IN2 jacks to program that device. Use the remote control that came with the device connected to the IN3 jacks to program that device. Use the remote control that came with the device connected to the IN4 jacks to program that device. Note: If you use a universal remote control to operate all your devices, follow the same procedure with switching the universal remote control into the mode associated with each device connected to the component video selector. Maintaining • Clean the component video selector with a dust cloth or dry cloth. • Do not submerge the component video selection in water.