Dynex DX-E101 Installation Guide (English) - Page 5

Dynex5x7-multi.book Page 5 Wednesday, September 14, 2005 9:09 AM Installing the adapter 5 3 Connect the other end of the cable to the WOL connector on the system board. 4 Turn on your computer and press Delete or F1 when prompted to enter the BIOS Setup utility. The keys you press to enter the BIOS Setup utility may vary. See your computer's user guide. Enable the WOL function or power-on function of the computer. The name of this function is system dependent, but it may be located in a category heading titled such as "Power Management." See your computer's user guide for more information regarding the BIOS Setup utility and BIOS settings. Installing the drivers WINDOWS XP To install the adapter drivers in Windows XP: 1 Make sure that you have installed the adapter into your computer and have connected the network cable. 2 Turn on your computer. After Windows XP automatically installs the drivers, a Found New Hardware message appears next to the clock on the Windows taskbar. 3 If Windows does not automatically install the drivers, follow the instructions in "Manually installing the drivers in Windows XP" on page 5. MANUALLY INSTALLING THE DRIVERS IN WINDOWS XP To manually install the drivers in Windows XP: 1 Click Start, right-click My Computer, then click Properties. The System Properties box opens.