Dynex DX-ECFW Quick Setup Guide (English) - Page 2

DX-ECFW_10-0792_QSG_V3_EN.eps 2 10/29/2010 2:58:46 PM 3 I am having difficulty connecting my camera or camcorder. • Check the cable connections to both the camera and adapter. • Make sure that the camera is turned on and has power running through it. • Check Device Manager to see if the camera is detected and installed. 1 Click Start, right-click My Computer (Windows 2000 & XP) or Computer (Windows Vista & 7), then click Properties. 2 Click Device Manager. If the camera is connected to the FireWire ExpressCard adapter, you see Microsoft DV camera and VCR under Imaging Device. • If the camera is not listed, check the cable connections to both the camera and adapter. Make sure that the camera is turned on and has power. OR The computer's operating system may need to be updated to support IEEE 1394 devices. Refer to either Windows or Apple Web sites to update the computer to the latest OS version or service pack. 4 I am having difficulty connecting another FireWire device. • Repeat the device driver installation procedures. • Check Device Manager to see if the device is recognized. • Make sure that the attached device driver is up to date. Updated device drivers are usually available for download on the device manufacturer's Web site. 5 During installation, Windows cannot locate the files needed to complete installation. 1 Insert your operating system's CD or DVD that came with your computer or the one you purchased when upgrading your operating system. 2 In the Copy files from field, change the file location to match the location of the operating system CD. If using Windows 2000 or XP, change to D:\i386 (if D: is the drive letter of the CD drive). Some files may exist on the system already but need to be located through Windows Search. Each computer may vary slightly. 6 How do I safely remove the device from my computer? • Double-click the Safely Remove Hardware icon on the system tray in the lower-right corner of your screen. When the window opens, click the the device you want to remove. A window should open telling you it's safe to remove the device. NOTE: In some cases when you use Safely Remove Hardware to remove your FireWire device from the computer, the entire FireWire adapter is disconnected. If this happens, remove your FireWire card from the ExpressCard adapter slot and re-insert. 7 The computer is recognizing the card, but not my device(s) connected to the card. • Make sure the device is turned on. • Remove the adapter from the ExpressCard slot of your laptop and re-insert it until it's firmly seated. • Repeat the device driver installation procedures. • Check the Device Manager to see if the device is listed. Specifications Chipset LSI FW643 Interface ExpressCard/1.34 inch (34 mm) Connectors • One 9-pin FireWire 800-1394b connector • One 6-pin FireWire 400-1394a connector Dimensions 1.69 × 4.49 × 0.79 inches (43 × 114 × 20 mm) Maximum data transfer rate • FireWire 800-1394b: 800 Mbps (or 100 MB/sec) • FireWire 400-1394a: 400 Mbps (or 50 MB/sec) System environment Operating temperature: 41°F~104°F (5°C~40°C) Operating humidity: 20% ~ 80% RH System support Windows 2000, Windows XP, Windows Vista, Windows 7, Mac OS X v10.4.x or higher Certification FCC Class B, ICES-003 Specifications are subject to revision or update without notice. One-year limited warranty Visit www.rocketfishproducts.com for details. © 2010 BBY Solutions, Inc. All Rights Reserved. DYNEX is a trademark of BBY Solutions, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners. ENGLISH 10-0792