Dynex DX-LCD22-09 User Manual (English) - Page 9
Connecting an antenna or basic cable, Connecting a cable or satellite box, Making audio and video - problem
View all Dynex DX-LCD22-09 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Setting up your TV Connecting an antenna or basic cable To connect an antenna or basic cable (no cable box): • Connect one end of a 75 ohm coaxial cable to the antenna or basic cable wall jack, then connect the other end of the cable to the RF (ANT) IN jack on the back of your TV. 9 An alternate method If you subscribe to a cable TV service in which basic channels are unscrambled and premium channels require the use of a converter/descrambler box, you may want to use a signal splitter and an A/B switch box (available from the cable TV company or an electronics supply store). Use the connections shown below. With the switch in the "B" position you can directly tune any nonscrambled channels on your TV. With the switch in the "A" position, tune your TV to the output of the converter/descrambler box (usually channel 3 or 4) and use the converter/descrambler box to tune scrambled channels. Antenna jack Coaxial (75 ohm) cable Notes: Always unplug the coaxial cable when you move your TV. If you want to switch between antenna and cable, install an antenna selector. If you need help connecting cable TV, contact your cable TV provider. To connect a combination VHF/UHF antenna with separate VHF and UHF 300 ohm twin-lead wires: • Connect the UHF 300 ohm twin-lead wire to the combiner (not supplied). Connect the VHF 300 ohm twin-lead wire to the 300-75 ohm matching transformer. Attach the transformer to the combiner, then attach the combiner to the RF (ANT) IN jack on the back of your TV. Connecting a cable or satellite box Note: Installation methods may vary depending on the type of cable or satellite box. Contact your cable or satellite provider for more information. To connect a cable or satellite box: 1 Connect a 75 ohm cable to the cable or satellite TV wall jack, then connect the other end to the Antenna IN jack on the cable or satellite TV box. Coaxial cable Cable or satellite box Splitter A/B switch Coaxial cable Antenna jack Making audio and video connections Cautions before connecting your TV • Carefully check the terminals for position and type before making any connections. • The illustrations of external equipment may be different than the equipment that you own. • Loose connections can result in image or color problems. Make sure that all connections are secure. • Refer to the operating manuals of your external equipment. • When connecting an external device, turn off the power to avoid any issues. Connecting a composite video device To connect a composite video device: 1 Connect an AV cable or S-Video cable to the VIDEO OUT or S-VIDEO OUT jack on the external device (such as a VCR), then connect the other end of the cable to the VIDEO IN or S-VIDEO IN jack on the back of your TV. Coaxial cable Cable or satellite box Coaxial cable Antenna jack 2 Connect a 75 ohm coaxial cable to the RF OUT jack on the cable or satellite TV box, then connect the other end to the RF (ANT) IN jack on the back of your TV. Back of TV VCR Notes: Cables are often color-coded to connectors. Connect red to red, white to white, and so on. S-Video cable S-VIDEO Composite video cable and audio L/R cables 2 Connect an RCA audio cable to the AUDIO L and R jacks on the video device, then connect the other end of the cable to the AUDIO L and R IN jacks on the back of your TV. 3 Press INPUT. The Input Source menu opens. 4 Select AV (or S-Video if using the S-VIDEO IN jack) to select the input source, then press ENTER to confirm. You can also select video input directly by pressing Video.