EVGA 130-SB-E685-KR User Guide - Page 20

EVGA Z68/P67 Motherboard The front panel header on this motherboard is one connector used to connect the following four cables. (see Table 2 for pin definitions):  PWRLED Attach the front panel power LED cable to these two pins of the connector. The Power LED indicates the system's status. When the system is powered on, the LED will be on. When the system is turned off, the LED is off. When the system is in S1, S3, S4 status, the LED will blink. Note: Some system cases do not have all four cables. Be sure to match the name on the connectors to the corresponding pins.  PWRSW Attach the power button cable from the case to these two pins. Pressing Table 2.Front Panel Header Pins the power button on the front panel turns the system on and off rather than using the onboard button.  HD_LED Attach the hard disk drive indicator LED cable to these two pins. The HDD indicator LED indicates the activity status of the hard disks.  RESET HD_LED PWRLED RESET PWRSW Pin Signal 1 HD_PWR 3 HD Active 2 PWR LED 4 STBY LED 5 Ground 7 RST BTN 6 PWR BTN 8 Ground Attach the Reset switch cable from No Connect 9 +5V the front panel of the case to these two pins. The system restarts when Empty 10 Empty the RESET switch is pressed.