EdgeStar CBR901SG Owner's Manual - Page 14
Cleaning And Maintenance, Troubleshooting
View all EdgeStar CBR901SG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Symptoms The beverage cooler turns on and off frequently. CLEANING AND MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. Exterior Cleaning The door and cabinet may be cleaned with a mild detergent and lukewarm water solution such as 2 tablespoons of baking soda to 1 quart of water. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting. If the door panel is stainless steel, it can discolor when exposed to chlorine gas and moisture. Clean stainless steel with a cloth dampened with a mild detergent and warm water solution. Never use an abrasive or caustic cleaning agent. Interior Cleaning The beverage cooler's interior should be cleaned occasionally. 1. Disconnect power to the unit. 2. Open the door and remove the contents and shelves. 3. Wait until the unit defrosts. 4. With a clean cloth, wipe down the interior of the unit. 5. Reinsert the shelves and beverages. 6. Reconnect power to the unit. TROUBLESHOOTING Before Calling for Help If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem persists, check the Troubleshooting Guide below and on the following page. The problem could be something that can easily be solved or explained. Possible causes The room temperature is higher than the recommended ambient environment. The door is being opened often. The door is not completely closed. The door gasket is not sealing properly. Solutions Run the cooler at the appropriate ambient temperature. Minimize the number of times the door is opened. Make sure the door is completely closed. Make sure the door gasket is properly sealing. The cooler does not have the Read and follow the "Installation Clearance suggested ventilation. Requirements" section. 11