EdgeStar CBR901SGDUAL Owner's Manual - Page 12
Installation Check List before Operation, Using the Temperature Control Panel
View all EdgeStar CBR901SGDUAL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION Installation Check List before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the beverage cooler? 2. Have the installation instructions been followed, including connecting the machine to electricity? And has proper grounding been installed for the beverage cooler? 3. Has the machine been leveled? 4. Is the beverage cooler in a site where the ambient temperature is between 50º F and 95º F all year round? 5. Is there a clearance of at least 2" to 3" at the rear for proper air circulation? Using the Temperature Control Panel Run Light Temp. Buttons Light Button Power Button RUN CF Celsius and Fahrenheit Lights Note: Whether your beverage cooler can reach the actual set temperature depends on the ambient environmental conditions. Set Display Current Temperature Use the up and down buttons to adjust the temperature. The temperature displayed can be in Fahrenheit or Celsius. This beverage cooler has a temperature range from 38°F to 50°F. This beverage cooler has two displays, a Set Display that shows the set temperature, and a Current Temperature Display that shows the current temperature. Note: It is normal to see the set temperature and current temperature displays being a few degrees off from each other. Press the button on the control panel to lower the temperature by 1 degree increments. Allow at least 24 hours before storing your beverages and to allow the temperature to acclimate. Press the button on the control panel to increase the temperature by 1 degree increments. Caution: If you powered off the unit, please wait at least 5 minutes before powering it back on. Press the button to turn the inner light on or off. Press and hold the power button for approximately 3 seconds to turn the unit's power on or off. The Run Light will illuminate when the unit is working. The Celsius or Fahrenheit light will be lit depending on what scale temperature is being displayed. To switch between C and F, press and hold the and buttons at the same time for approximately 5 seconds until the temperature scale changes. 9