EdgeStar CWD1510SPORTK Owner's Manual - Page 10

Note: When you plan to dispose of this machine in the future, please comply with the local waste disposal regulations. Remove the door so that children and pets will not be trapped in the machine. Electrical Requirements Failure to follow electrical requirements can cause personal injury, fire, or electrical shock. Install the combo washer/dryer according to the manufacturer's instructions and local codes. To reduce the risk of severe injury or death, follow all installation instructions. Save these instructions even after installation is complete.  Properly ground in accordance with all local codes and ordinances. If there is a short circuit, proper grounding can reduce the danger of electrical shock.  It is the responsibility and obligation of the product owner to have a proper outlet installed by a qualified technician.  This washer is equipped with a properly grounded 3 prong plug.  Do not remove ground prong. Do not use an adapter or extension cord. Plug into a grounded 3 prong outlet.  Do not overload the outlet with more than one appliance. Location Requirements Selecting the proper location for your washer improves performance and minimizes noise and possible washer "walk". Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. Proper installation is your responsibility. You will need:  A water heater set to deliver 120°F (49°C) water to the washer.  A grounded electrical outlet located within 6 ft. (1.8 m) of where the power cord is attached to the back of the washer. See "Electrical Requirements."  Hot and cold water faucets located within 4 ft. (1.2 m) of the hot and cold water fill valves, and water pressure of 20 - 100 psi (137.9 689.6 kPa) .  A level floor with a maximum slope of 1" (25 mm) under entire washer.  Washer should be installed on a rigid, dry, and level surface. Soft floor surfaces such as carpets or surfaces with foam backing are not recommended.  A sturdy and solid floor to support the washer with a total weight (water and load) of 200 lbs.  Store and install the washer where it will not be exposed to outdoor weather conditions.  Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.  Avoid direct sunlight and make sure there is sufficient ventilation.  Keep far away from heat sources such as coal or gas.  Make sure that the washing machine will not stand on its power cord and is accessible. 5