EdgeStar CWD1550BL Owner s Manual - Page 23

Operating the Washer Now that installation is complete and you have read and fully understand the features of this machine, you are now ready to proceed with using your new Combo Washer / Dryer. Make sure the unit is connected to power and ensure water lines are connected properly; the supply valves should be opened completely. Place your pre-sorted wash load into the drum. Press the "On / Off" button. The control panel will illuminate. Turn the cycle selector knob to the desired cycle based on load. The LED display panel will reflect the preset features for that cycle. If you would like to modify any of the preset settings for the chosen cycle you may adjust individual options until the display panel reflects desired settings. Please Note: Not all settings can be adjusted for each cycle. Refer to the Cycle Guide chart for default settings and available options for each specific cycle. Ensure that the door is properly closed and press the Start/Pause button to begin cycle. Once the cycle begins, the door will automatically lock and the wash cycle will begin. The display panel will change to reflect estimated time and stage of the cycle. At any time you can pause the cycle by pressing on the Start/Pause button again. The Pause button can be used in order to add or remove items from the wash tub once a cycle has started. When you press Pause, the unit will sense the water level in the tub and drain water if necessary prior to releasing the door lock so that you may open the door. Please Note: If the door is open and the Start button is pressed, the unit will attempt to engage the door lock for approx. 30 seconds during which time you may close the door and the cycle will proceed uninterrupted. If the door remains open and the door lock cannot engage, the unit will automatically drain (for up to 5 minutes) and will then display the open door error code. If this occurs, power the unit Off and back On and proceed as normal. EdgeStar Combo Washer/Dryer 18