EdgeStar KC3000SS Owner's Manual - Page 5
Installing the Casters, Installing the Beer Tower and Faucet, Installing the Guardrail
View all EdgeStar KC3000SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY INSTRUCTIONS Installing the Casters 1. With the contents inside the cabinet removed set the beer dispenser on its side. 2. Insert each caster into the holes on the bottom corners of the cabinet. Screw the casters in hand tight. 3. With all four casters tightened evenly, stand the unit in an upright position. Note: Allow the refrigerator to stand in an upright position for 8 hours before turning on the power. This will ensure that the coolant has settled. Installing the Beer Tower and Faucet 1. Remove the cabinet plug located on the top of the unit. Firmly grasp and twist and pull upward. (It may help to open the cabinet and push up on the cabinet plug with your hand from inside the unit). Note: You should store this plug in a safe place as it is required to convert the beer dispenser into a refrigerator 2. Take the tower and untangle the tubing. From the top of the unit, feed the tubing through the hole and into the unit. 3. Align the bottom of the tower with the hole in the top of the cabinet and match up the openings for the screws. Install the four screws to fasten the tower into place. 4. Align the faucet handle to be parallel with the beer tower with the spigot facing downward and screw in the faucet counter-clockwise with your hands 5. Set the plastic drip pan into place below the faucet. Installing the Guardrail 1. Snap the guardrail into the top of the cabinet's guardrail pilot holes. 5