EdgeStar PDW45E Owner's Manual - Page 10

13. You can select another program during operation by pressing the start/pause key first, then pressing the program key to the desired program, and pressing the pause/start key again to start the new program. 14. After washing, dishes should be allowed to cool down for about 15 minutes so they are not too hot to handle. Dishes will cool more quickly if the door is opened slightly. 15. After unloading the dishwasher, remove the filter, clean off any bits of food, and put the filter back into place. NOTE: At the beginning of each cycle, the dishwasher always starts in the "drain" mode. This is because the drain pump always retains a small amount of water (in the sump) from the previous cycle. This is necessary to keep the pump primed. Therefore, do not be alarmed if you see a small amount of water being pumped out of the drain hose prior to the start of the regular wash cycle. This is normal. Program Summary/Selection Intensive Wash Water Temperature: Wash129/Rinse264rF Program Duration + Heating Time: 125minutes Water Consumption: 11 quarts Normal wash:: Water Temperature: Wash125/Rinse152rF Program Duration + Heating Time: 130 minutes Water Consumption: 11 quarts Rapid wash: Water Temperature: Wash120/Rinse130rF Program Duration + Heating Time: 70minutes Water Consumption: 10 quarts Eco Wash: Water Temperature: Wash129/Rinse264rF Programme Duration + Heating Time: 120 minutes Water Consumption: 11 quarts Pre-Wash : Water Temperature: Programme Duration Time: Water Consumption: Incoming Water Supply 12 minutes 5.7 quarts (Note: the washing time may vary according to the incoming water temperature and the ambient temperature). Technical Data and Troubleshooting Technical data Power input Outer dimensions (HxWxD) Weight Max. Water Consumption Water pressure Controls Detergent dosage 1160W 17.1"x18.9"x22.5" 50 pounds 2.75 gallons 0.03~1MPa Digital 12g 8