Edimax ES-3208P Quick Install Guide - Page 5
Connecting the power, Trouble Shooting
View all Edimax ES-3208P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3. Connecting the power Connect the power adapter to the power connector on the rear panel of the unit; the green Power LED on the front panel should be lit. Trouble Shooting 1. Power LED is not lit z Check if the power cord is properly connected to the external power adapter and the power outlet. Make sure the power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connect to 10/100Mbps devices z Check the power switch of the network device attached to the switch; make sure it is turned ON. z Check the network cable; make sure it is properly connected to the switch and the network device. z Check the network cable; make sure the UTP cables comply with EIA/TIA 568 and Category 5 specification. z Make sure maximum cable length between the switch and connected device is 100 meters (300ft). [!] Contact your dealer if problem persist. 4