Edimax PRI-885 Available from Edimax USA User Manual - Page 45
connect to Dial Up DSL
View all Edimax PRI-885 Available from Edimax USA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
-Disable: no Healthy Check function, if without "Time Server" exist, this function will disable automatically Healthy Check can be set up to test 3 different destination IP, in order to avoid Wrong operation. ( in case destination server fail) WAN TYPE Three kinds of WAN types to let you select on each WAN port: 1. [Dynamic IP] . connect to CABLE MODEM. Obtain an IP address from ISP automatically. Usually it's used to connect CABLE modem. You won't need to assign IP Address, the Broadband Router will get the IP address for you automatically. 2. [PPPoE] (Gateway / Basic NAT Mode only) . connect to Dial Up DSL Some ISPs require use of PPPoE to connect to their service. Connect to ISP via dial-up connecting, ISP will assign a legal IP to you after the user Id and password had been passed when the connection is made (The user Id and password here are provided by your ISP.) 3. [Static IP] . connect to Leased DSL ISP assigns you a static IP address. When used the leased line of ADSL. ISP will provide you the relative IP, Subnet Mask, Gateway and DNS. You need to indicate the static IP manually. SCHEDULE This function allow you to control each WAN port link up/down time by daily/weekly Start Time (hh: mm) End Time( hh: mm) Using 00 ~23 to indicate Hours. Example 17:00 means 05:00 PM Weekly: choose by day Note: When enable SCHEDULE function, the Line will up/down following the timer set, no matter DOD function is enable or not. WAN SPEED: you need to enter speed of each WAN port (K bps) Otherwise ROUTER will not work properly in Load Balance: Traffic Mode Bandwidth Usage Control WAN Link Mode: You can choose WAN port work mode with ADSL modem Auto Sense 10Mbps Half Duplex 45