Edimax PS-1206UWg Manual - Page 81
Load Default, Wireless Function
View all Edimax PS-1206UWg manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Note that before you upgrade the firmware please make sure that the IP Address settings of the print server are in the same network as your computer. Load Default: If you want to reset the Print Server to default factory settings, please click "Load Default". Wireless Function: You can select "Auto", Enable" or "Disable" to manually configure the wireless function. Auto - "Auto" is the default setting of the print server. At this mode, the print server will automatically decide to enable or disable the wireless function. When the print server starts up, it will auto-detect if the LAN port is connected to an active network by an Ethernet cable. If this is the case, the print server will run in Ethernet mode. If the print server is not connected to an active network by Ethernet cable, the print server will run in wireless LAN mode. Users can plug the Ethernet cable to the print server at the first, after configuring the print server features and wireless settings; they can unplug the Ethernet cable to enable the wireless connection. It makes the configuration much easier without creating the wireless connection in advance. Note: After you have set the wireless function, please remove the Ethernet cable and then re-plug the power jack of the print server to activate the wireless connection. Enable - Enable wireless function only, the print server's wireless LAN will be always enabled and Ethernet will be always disabled. Disable - Disable the wireless function, the print server's wireless LAN will be always disabled and Ethernet will be always enabled. 72