Electrolux E30WD75GSS Installation Instructions - Page 2
Important Safety, Instructions - parts
UPC - 057112097695
View all Electrolux E30WD75GSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions for future reference. IMPORTANT SAFETY Use screws INSTRUCTIONS supplied to attach drawer to front of Figure 2 • Be sure your appliance is installed and plugged cabinet. into a 120 Volt grounded outlet. • This appliance must be electrically grounded in Model and Serial Number Location accordance with the National Electrical Code ANSI/ The serial plate is located as shown below. NFPA No. 70-latest edition in the United States, When ordering parts for or making inquiries about your or CSA C22.1, Part 1 in Canada, and local code Warm & Serve Drawer, always be sure to include the requirements. model and serial numbers and a lot number or letter from Tools You Will Need the serial plate on your Warm & Serve Drawer. Phillips® Screwdriver Pencil Ruler or Tape Measure and Straight-edge Hand Saw or Saber Saw Spirit Level Warm & Serve Drawer Installation 1.Locate the 2 anti-tip brackets supplied as shown on fig. 1. c/c 25 5/16" (64.3 cm) Serial Plate Location Combination Warm & Serve Drawer and Cooktop Installation A c/c 12 21/32" (32.15 cm) 24" (64.3 cm) Max. 23 5/8" (60 cm) Min. Figure 1 2.Slide drawer into cutout opening until front frame of drawer is flush against cabinet. Be careful not to pinch electrical cord. 3.Remove the drawer as instructed in the Use & Care Guide and secure drawer housing to cabinet using the 3 nickel-plated screws supplied (see Figure 2). Do not overtighten screws. 4.The 60" (152 cm) appliance power cord can now be connected into the 120 Volt outlet. 5.Proceed with mounting built-in oven above the drawer (if applicable). Follow installation instructions provided with built-in oven. Make sure to use anti-tip brackets supplied with the built-in oven. Minimum Depth Spacing To Clear Cooktop Burner Box Electric Cooktop Spacing "A" Gas Cooktop E30IC75, E36IC75 E30EC65, E36EC65 E36EC75 E30EC70, E36EC70 4.5" (11.43cm) 6.0" (15.24cm) 7.5" (19.05cm) 8.5" (21.59cm) 5.0" (12.7cm) E36GC75 2