Electrolux E32AR75FPS Specification sheet - Page 2

Built-In All Refrigerator E32AR75FPS professional series Recessed electrical outlet 24" Cabinet Top View Cabinet Side Panels 3/4" min. width (with Louvered Trim Kit) 25" Countertop 26 3/4" Water filter connection location (left top rear) 32" 21/32" (hinge height) 69 1/4" min. 70 1/4" max.* 65 1/8" A Louvered Trim Kit C B Cutout Dimensions Built-In All Refrigerator (without Trim Kit & Riser) Single Unit Installation (A) 66" (B) 33" (C) 251/4" min.* Double Unit Side-by-Side Installation (A) 66" (B) 66" (C) 251/4" min.* Built-In All Refrigerator (with Louvered Trim Kit & Riser) Single Unit Installation (A) 79" (B) 33" (C) 251/4" min.* Double Unit Side-by-Side Installation (A) 79" (B) 66" (C) 251/4" min.* Allow at least 571/4" with door in 90° open position Shown with optional 4" trim kit riser Power cord location (right bottom rear) * Height includes cabinet plus 24 1/4" 4" riser (21/32" hinge 29 5/16" to handle height not extension included) Note: Optional Louvered Trim Kits available for Built-In All Refrigerator. For specifications, refer to Louvered Trim Kits Installation page on web. *Minimum depth from face of cabinet side panels and requires recessed electrical outlet. 32" Built-In All-Refrigerator Specifications • Product Weight - approx. 275 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (NFPA 70) and local codes & ordinances. • Voltage Rating - 115V / 60 Hz / 15 or 20 Amps • Connected Load (kW Rating) @ 115 Volts = 0.55 kW • Amps @ 115 Volts = 5 Amps • Always consult local and national electric & plumbing codes. • Minimum opening of 66" H x 33" W x 25-1/4" D required for single-unit "Built-In Look" installation; 66" W required for double-unit installation. (66" H to be measured from finished floor to underside of soffit or overhead cabinet.) • Remove all wall / floor molding prior to built-in installation. • Water filter system for All-Freezer model E32AF75FPS ice maker is located in All Refrigerator. For side-by-side installation, refer to web for details on ice maker water supply hookup. If All-Freezer unit is to be installed alone, direct plumbing recommended. • Minimum 25-1/4" depth requires recessed electrical outlet. • When installing next to wall where handle may make contact, allow 4" minimum clearance for 90° door swing. At 90° door stop position, drawer access will be maintained but removal will be restricted. • Refrigerator must be placed on level surface of hard material, same height as flooring. Surface must support approximately 600 lbs. when fully loaded. Unit equipped with 4-point leveling. • If optional Single or Double Louvered Trim Kit is to be used, different cutout dimensions are required. (Refer to cutout dimensions on this page and to Louvered Trim Kits Installation Specifications page on web.) Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions. Optional Accessories • Single Louvered Trim Kit - (PN # SRRRSRKIT). • Double Louvered Trim Kit - (PN # DUORSRKIT). Electrolux Major Appliances, N.A. USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxicon.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxicon.ca E32AR75FPS 09/09 © 2009 Electrolux Home Products, Inc. High standards of quality at Electrolux Home Products, Inc. mean we are constantly working to improve our products. We reserve the right to change specifications or discontinue models without notice. Printed in the U.S.A.