Electrolux E48DF76EPS Owners Guide - Page 42

Solutions to Common Problems

Get Electrolux E48DF76EPS - 48inch Pro-Style Dual-Fuel Range PDF manuals and user guides View all Electrolux E48DF76EPS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

42 Solutions to Common Problems PROBLEM POSSIBLE CAUSE SOLUTION Nothing works. Oven is not connected to electrical power Have oven connected to a properly sized electrical power supply by a qualified technician. Oven will not heat. Power supply is not energized. Oven settings are not correct. Have an electrician check power supply, including the house circuit breaker, wiring and fuses. Follow mode selection and temperature settings as specified in OVEN OPERATION. Foods overcooked. Incorrect cooking time, temperature. Adjust time, temperature or rack position. Oven does not Self-Clean. Oven light will not work. Door is not closed tightly, so the automatic door latch will not lock. Close door tightly. Oven control knob set incorrectly. Follow mode selection and temperature settings specified for SELF-CLEAN. Light bulb is burned out. Follow REPLACING THE OVEN LIGHT. Door will not open. Oven is in Self-Clean mode. If oven is hot, door latch will release automatically when oven temperqature falls below 490°F at end of cycle. Oven will not heat after Self-Clean. Oven settings not correct. Follow mode selection and temperature settings as specified in OVEN OPERATION Igniters do not spark. Circuit breaker is tripped. Reset circuit breaker House fuse is blown. Replace house fuse. Power outage in local area. Contact power company. Sparking but no flame ignition Gas shut-off valve is in the "off" position. Turn shut-off to "on" position. Gas supply is interrupted. Contact gas company. Burners ignite but flame is extremely large, distorted or yellow. Burner ring ports are clogged. Clean burner ring ports with straightened paper clip, needle or wire. Burner ports or burner caps are not positioned properly. Remove and carefully re-install burner rings and caps. Cooktop is being operated on the wrong type of gas. Ensure that the type of cooktop matches the gas supply (natural gas or L.P. gas) Regulator is not installed, is faulty or is set for the wrong type of gas. Check installation, replace regullator, or set regulator for proper gas. Burner flame goes out at low setting. Low gas supply pressure. Contact gas company. Ignitors spark continuously after flame ignition. Power supply is not grounded. Power supply polarity is reversed. Have power supply properly grounded. Have polarity corrected. Ignitors are wet or dirty. Dry or clean ignitors.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
42
Solutions to Common Problems
PROBLEM
POSSIBLE CAUSE
SOLUTION
Nothing works.
Oven is not connected to electrical power
Have oven connected to a properly sized
electrical power supply by a qualified technician.
Power supply is not energized.
Have an electrician check power supply,
including the house circuit breaker, wiring and
fuses.
Oven will not heat.
Oven settings are not correct.
Follow mode selection and temperature
settings as specified in OVEN OPERATION.
Foods overcooked.
Incorrect cooking time, temperature.
Adjust time, temperature or rack position.
Oven does not Self-Clean.
Door is not closed tightly, so the automatic door
Close door tightly.
latch will not lock.
Oven control knob set incorrectly.
Follow mode selection and temperature settings
specified for SELF-CLEAN.
Oven light will not work.
Light bulb is burned out.
Follow REPLACING THE OVEN LIGHT.
Door will not open.
Oven is in Self-Clean mode.
If oven is hot, door latch will release
automatically when oven temperqature falls
below 490
°
F at end of cycle.
Oven will not heat after Self-Clean.
Oven settings not correct.
Follow mode selection and temperature settings
as specified in OVEN OPERATION
Igniters do not spark.
Circuit breaker is tripped.
Reset circuit breaker
House fuse is blown.
Replace house fuse.
Power outage in local area.
Contact power company.
Sparking but no flame ignition
Gas shut-off valve is in the "off" position.
Turn shut-off to "on" position.
Gas supply is interrupted.
Contact gas company.
Burners ignite but flame is extremely
Burner ring ports are clogged.
Clean burner ring ports with straightened paper
large, distorted or yellow.
clip, needle or wire.
Burner ports or burner caps are not positioned
Remove and carefully re-install burner rings and
properly.
caps.
Cooktop is being operated on the wrong type
Ensure that the type of cooktop matches the gas
of gas.
supply (natural gas or L.P. gas)
Regulator is not installed, is faulty or is set for
Check installation, replace regullator, or set
the wrong type of gas.
regulator for proper gas.
Burner flame goes out at low setting.
Low gas supply pressure.
Contact gas company.
Ignitors spark continuously after flame
Power supply is not grounded.
Have power supply properly grounded.
ignition.
Power supply polarity is reversed.
Have polarity corrected.
Ignitors are wet or dirty.
Dry or clean ignitors.