Electrolux EFDE317TIW Complete Owner s Guide English - Page 21
Solutions to Common Inquiries
![]() |
View all Electrolux EFDE317TIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Solutions to Common Inquiries Common Drying Inquiries Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association. PROBLEM Greasy, oily stains POSSIBLE CAUSES • Fabric softener sheet. Lint • Overloading. • Overdrying causes static electricity. • Lint screen not clean when cycle began. • Lint is attached to "pills." Pilling (Fibers break off, ball up and cling to fabric.) • Overdrying. Shrinking • Temperature too high. • Overdrying. SOLUTIONS • Rub fabric softener stains with bar soap. Rinse and rewash. • Reduce load size and rewash using liquid fabric softener in the final rinse. • Or, add a fabric softener sheet and tumble without heat. • Use lint brush or roller to remove lint. • Use a lint brush or shaver to remove pills. • Irreversible condition. PREVENTIVE MEASURES • Add a few bath towels to small loads for proper tumbling. • Some "silk-like" fabrics should be air dried. • Use proper drying temperature. • Place fabric softener sheet on top of load before starting the dryer. • Do not overload dryer. • Use fabric softener in washer or dryer to reduce static electricity. • Remove items when they are slightly damp to avoid overdrying. • Check that lint filter is clean and in place. • Use fabric softener to lubricate fibers. • When ironing, use spray starch or fabric finish on collars and cuffs. • Turn items inside out to reduce abrasion. • Follow fabric care label directions. • If shrinking is a concern, check load often. • Remove items while slightly damp and hang or lay flat to complete drying. • Block knits into shape. Wrinkling • Overloading. • Leaving items in dryer after cycle ends. • Reduce load size and • Do not overload dryer. tumble at medium or low • Remove items as soon as heat for 5-10 minutes. cycle ends. • Remove items immediately. Hang or fold. Isolated wet • Low water line pressure spots on fabrics in home is not sufficient to after completed atomize incoming water Steam cycle during Steam cycle • Check water line pressure • Ensure water line pressure is minimum of 20 psi. Do not exceed 120 psi. 21
![](/manual_guide/products/electrolux-efdg317tiw-complete-owner-s-guide-english-65f941b/21.png)