Electrolux EFLS210TIW Product Specifications Sheet English - Page 3

IQ-Touch Compact Front Load Washer FRONETFLLOSA2D1W0TAS(HsEteRaSm) EFLS210T IS / IW Front 24" 33 1/2" min. (68 1/2" min. for stacked units) Left 42" 25" Rear 120V Power cord H/C Water inlets Drain hose Built-In Installations For built-in installations, NO minimum clearance required around sides, backs and tops of units. Location of plumbing and utility hookups MUST be considered in built-in installations. For additional installation details, refer to Product Installation Guides on web. 90° 90° 68 1/2" min. (includes stacking kit) Dryer 90° Countertop 48" min. 90° 33 1/2" min. Washer Dryer 25" Side-by-Side Units in Under-Counter Installation Washer 26" 24" min. Stacked Units in Recessed Alcove Installation For detailed stacked installation, refer to instructions included with Stacking Kit or on web. Note: Stacking Kit adds 1" to overall depth of stacked units. Front Load Washer Specifications • Product Weight - 174 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI / NFPA 70) and local codes & ordinances. (Do not use same circuit as dryer.) • Voltage Rating - 120V / 60Hz • Connected Load (kW Rating) @ 120 Volts = 1.3 kW • Amps @ 120V = 10A • Equipped with 120V 3-wire power supply cord, approx. 59" long. • Always consult local and national electric & plumbing codes. • To maximize detergent effectiveness, ambient temperature should never be below 60°F. • Can be installed alone or stacked beneath matching Electrolux Dryer, which requires installation of optional dryer stacking kit. (For installation details, refer to instructions included with stacking kit or on web.) • Can be built in with matching Electrolux Dryer in under-counter or recessed alcove installation with NO minimum clearance required around sides, backs and tops of units. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.) • Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables are kept or stored. • For garage installation, washer MUST be located minimum 18" above floor. • Floor MUST be solid with 1" maximum slope. To ensure vibration or movement does not occur, reinforcement of floor may be necessary. Do NOT install on carpeted surface. • Leveling legs supplied to level washer properly and reduce excessive noise and vibration. • H / C water faucets MUST be installed within hose length of washer's water inlet and MUST be 3/4" garden hose type, to connect to inlet hoses. • Water pressure MUST be between 10 and 110 psi with NOT more than 10 psi pressure difference between hot and cold. • Drain required with standpipe diameter of 1-1/4" min. and height of 24" min. / 56-1/2" max. above floor, capable of eliminating 6 gallons per minute. Drain hose length approximately 55". Note: When installing with matching Condensation Dryer using Direct Condensation Drain Hose Kit, standpipe height must be located 40" max. above bottom of dryer's leveling legs. Note: F or planning purposes only. Refer to Product Installation Guide on the web at electroluxappliances.com for detailed instructions. Optional Accessories • Dryer Stacking Kit - Stainless Steel with Drawer (PN # STACKIT24S), White with Drawer (PN # STACKIT24W), No Drawer (PN # STACKIT24C). Electrolux Major Appliances, N.A. USA • 10200 David Taylor Drive • Charlotte, NC 28262­­• 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca EFLS210T 08/17 © 2017 Electrolux Home Products, Inc. High standards of quality at Electrolux Home Products, Inc. mean we are constantly working to improve our products. We reserve the right to change specifications or discontinue models without notice.