Electrolux EFLS517SIW Installation Instructions English Spanish French - Page 10
Connecting drain and electrical - reviews
View all Electrolux EFLS517SIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Installation Instructions Connecting drain and electrical 1. Verify the anti-siphon disc is in place. 2. Form a "U" shape on the end of the drain hose with the hose pointed toward the drain. Place the formed end in a laundry tub or a standpipe and secure the drain hose with the cable tie (provided in the enclosure package) to the standpipe, inlet hose, laundry tub, etc. so the hose does not pull out from the force of the water. NOTE The standpipe inside diameter must be 1-1/4" (3.2 cm) minimum. There must be an air gap around the drain hose in the standpipe. A snug hose fit can cause a siphoning action. IMPORTANT Check to ensure the power is off at a circuit breaker/fuse box before plugging the power cord into an outlet. 3. Plug the power cord into a grounded outlet. Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power cord with 3-prong grounded plug CABLE TIE 4. Turn on the power at a circuit breaker/fuse box. 5. Carefully slide the washer to its final position. Recheck for level and rock corners for stability. Remove and discard door tape. 6. Read the Use & Care Guide provided with the washer. It contains valuable and helpful information that will save you time and money. 7. Run the washer through a complete cycle, checking for water leaks and proper operation. 8. If you have any questions during initial operation, please review the "Service Prevention Checklist" in your Use & Care Guide before calling for service. 9. Place these instructions in a location near the washer for future reference. NOTE A wiring diagram and technical data sheet are located under the washer top panel, on top of the detergent dispenser housing. ANTI-SIPHON DISC