Electrolux EFLW317TIW Product Specifications Sheet English - Page 3

Electrolux FRONT LOAD WASHER EFLW317TIW Front 27" 38" (75 3/4" min. for stacked units) Left 32" 50 5/8" Rear 7 1/2" 3" 7" 2 1/2" 3" 120V H/C Drain 351/2" Power Water hose 35" cord inlets (approx. (approx. 59") 321/2" 60") 15" Pedestal Drawer Installation Elevates washer height to 53 1/4". For detailed pedestal installation, refer to instructions included with pedestal or on web. Pedestal Installation may require modified utility hookup locations. For details, refer to Product Installation Guide on web. 27" Front 15" 26 1/2" Side Overall depth with drawer fully extended - 421/2" 15 1/4" Built-In Installations 0" min. 0"min. 0"min. 1" min. Front Vented door Side 3" 60" sq. in. min. 60" sq. in. min. 3" Closet Installation: If washer and dryer are installed in same closet, door(s) MUST be vented with 120 sq.in. minimum louvered opening, equally divided, located 3" from top and bottom of door. Louvered door(s) with equivalent air openings for full-length of door is acceptable. Air openings MUST remain unobstructed with door(s) installed. Installation Clearances: Washer can be built in alone or with dryer (side by side or stacked) in closet, recess or under counter installation with 0" minimum clearance required around sides and back of unit(s). To achieve 0" minimum rear clearance when installed with dryer, dryer MUST be vented straight back or with quick-turn 90° elbow. Installation of closet door(s) requires additional 1" minimum clearance between front of unit(s) and door(s). Location of plumbing, exhaust and utility hookups MUST be considered when planning any built-in installation. For additional installation details, refer to Product Installation Guides on web. Under Counter Installation: Installation of washer alone or side by side with dryer under counter, requires custom-built countertop and/or cabinetry to accommodate unit(s) height. Stacking Units: Stacking dryer above washer requires use of optional Stacking Kit (PN# STACKIT7X) with modified utility hookup locations for dryer. For complete installation details, refer to instructions included with Stacking Kit or on web. Front Load Washer Specifications • Product Weight - 237 Lbs. / Shipping Weight - 247 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI / NFPA 70) and local codes & ordinances. (Do not use same circuit as dryer.) • Voltage Rating - 120V / 60Hz • Connected Load (kW Rating) @ 120 Volts = 1.2 kW • Amps @ 120V = 12A • Equipped with 120V 3-wire power supply cord, approx. 60" long. • Always consult local and national electric & plumbing codes. • To maximize detergent effectiveness, ambient temperature should never be below 60°F. • Can be installed alone, with or without optional 15" pedestal drawer, or stacked beneath matching Electrolux Dryer, which requires installation of optional dryer stacking kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.) • Can be built in alone or with matching Electrolux Dryer (side by side or stacked) in closet, recess or under counter installation with 0" minimum clearance required around sides and back of unit(s). To achieve 0" minimum rear clearance when installed with dryer, dryer MUST be vented straight back or with quick-turn 90° elbow. Installation of closet door(s) requires additional 1" minimum clearance between front of unit(s) and door(s). Location of plumbing, exhaust and utility hookups MUST be considered when planning any built-in installation. • Under-counter installation requires custom-built countertop and/or cabinetry to accommodate unit(s) height. • Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables, including automobiles, are kept or stored. • For garage installation, washer MUST be located minimum 18" above floor. • Floor MUST be solid with 1" maximum slope. To ensure vibration or movement does not occur, reinforcement of floor may be necessary. Do NOT install on carpeted surface. • Leveling legs supplied to level washer properly and reduce excessive noise and vibration. • H / C water faucets MUST be installed within 42" of washer's water inlet and MUST be 3/4" garden hose type, to connect to 48-1/2" inlet hoses. • Water pressure MUST be between 20 and 120 psi with NOT more than 10 psi pressure difference between hot and cold. • Drain required with standpipe diameter of 1-1/4" min. and height of 24" min. / 96" max. above floor, capable of eliminating 17 gallons per minute. Attached 59" drain hose can reach 79"-high standpipe. Note: F or planning purposes only. Refer to Product Installation Guide on the web at electroluxappliances.com for detailed instructions. Optional Accessories • Pedestal Drawers - Island White (PN # EPWD157SIW). • Dryer Stacking Kit - (PN # STACKIT7X). • Drain Hose Extension Kit - (PN # 137098000). Electrolux Major Appliances, N.A. USA • 10200 David Taylor Drive • Charlotte, NC 28262­­• 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca EFLW317T 03/17 © 2017 Electrolux Home Products, Inc. High standards of quality at Electrolux Home Products, Inc. mean we are constantly working to improve our products. We reserve the right to change specifications or discontinue models without notice.