Electrolux EFME627UTT Complete Owners Guide English - Page 22
hoses from ASSEMBLY HOSE KIT, Cold Inlet Hose, to Washer, Rubber Washer, Must be Present
View all Electrolux EFME627UTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
22 Installation Rubber Washer Must be Present and Undamaged Cold Inlet Hose to Washer 3. Turn on COLD supply and run water to clear any contaminants in the line. Short Hose "Y" Connector Water Inlet on Dryer Cold Water Supply Hose to Washer 6. If there is not room to install the "Y" connector directly, thread the short extension hose on to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. 4. Inspect hose couplings for proper placement of rubber washers. Use hoses from ASSEMBLY HOSE KIT# 5304495002 (not included). Rubber Washers MUST BE PRESENT 5. If your installation has room for the COLD water supply to accept the "Y" connector directly, thread the "Y" connector to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. NOTE If you were able to install the "Y" connector directly to the COLD water supply, please skip to step 8. 7. Thread the "Y" connector to the short extension hose and snug it by hand; then tighten it another 2/3 turn with pliers. 8. Connect the COLD inlet hose for the washer to the "Y" connector and snug it by hand; then tighten it another 2/3 turn with pliers. 9. Connect the straight end of the long hose from the kit to the other outlet on the "Y" connector and snug it by hand. Connect the hose's 90° coupling to the brass water inlet on the back of the dryer and snug it by hand. Tighten each connection of the dryer inlet hose another 2/3 turn with pliers. 10. Turn on the water and check for leaks at all connections.