Electrolux EI15TC65HS Complete Owner's Guide (English) - Page 5

Installation  Your compactor has been designed to require minimum space without loss of capacity whether free-standing or built-in. Built-in Installations mounting straps Free Standing top of compactor As shipped, the Compactor is only configured for built in installations. This appliance can be converted from builtin to free-standing with the use of Toe Kick Accessory Kit Model ETC15TKH (sold separately). If additional cord length is required for free-standing installation, remove the cord clamp and wire tie on the back of the unit. CAUTION: Failure to use Toe Kick Accessory Kit Model ETC15TKH in a free-standing installation may cause the compactor to be unstable during operation. front of compactor Two under-counter mounting straps are provided. Use these straps to secure the compactor to the underside of a countertop. Fasten the slotted end of the straps to the compactor using the holes in the top of the compactor cabinet as shown. NOTE: When installing compactor under granite or solidsurface countertops, bend the mounting straps so they can be secured to the adjacent cabinetry. under-counter opening 15" w 24" d 345/8" h electrical oOuptenlinegt 15" Wide 34-11/22""Hmighin. 22" Deep The compactor requires an under-counter opening 15-in. wide, 345/8-in. high, and 24-in. deep. Plan to provide an electrical outlet in the opening that meets all applicable electrical codes and requirements. See "Grounding Instructions" section on Page 3 for specific information. cord clamp The compactor is equipped with a 6-ft. long power cord. Use the cord clamp to prevent excess power cord from being pinched beneath the cabinet during installation or service. cord clamp