Electrolux EI24ID50QS Complete Owner's Guide (English) - Page 7

Operating Instructions 7 Energy Option Selections Hi-Temp Max Dry When HI-TEMP option is selected, the dishwasher heats water in the main wash to approximately 1400F (600C). MAX DRY is available on Auto, Heavy, Normal, Upper and Stemware cycles The cycle time will increase when MAX DRY option is selected. This increase in water temperature helps dishwasher detergent remove food, grease and soil from dishes more effectively and aids in drying. HITEMP option can only be used with AUTO, HEAVY, NORMAL and UPPER cycles. Operation Selection Delay Sanitize To sanitize your dishes and glassware, select the SANITIZE option. This option heats the water temperature in the final rinse to 1570F (69.40C) and maintains that temperature for 7 minutes. SANITIZE is available in Auto, Heavy, and Normal cycles. Only these sanitization cycles have been designed to meet NSF requirements. The cycle time will be extended until the proper water temperature is reached. Washing action will continue during the water heating delay. For best results, the incoming water temperature should be at least 1200F (490C). If the SANITIZE option is selected, the led above the pad comes on. The sanitization criteria may not be satisfied if there is an interruption of the cycle, a power failure occurs, or if incoming water temperature is below 1200F (490C). Sanitize led flashes at the end of the cycle if the NSF requirements for sanitization are not reached. Child Lock Controls/Air Dry To prevent children from accidently changing the dishwasher cycle or starting the dishwasher, lock the dishwasher controls by pressing the AIR DRY pad until "Loc" shows in the status window. The controls are locked and no new selections can be made until the lock is released. To unlock the controls, press the AIR DRY pad until "Loc" disappears. If child lock is activated the dishwasher will not work. The Delay Start option allows you to automatically delay starting your dishwasher from 1 to 24 hours. Press DELAY pad until the desired delay time shows in the Status window then press START to activate. Display will indicate the delay start time and will countdown until cycle starts. To cancel the DELAY option and begin the cycle before the delay period is over, press the CANCEL pad and then the START pad. Start To start a cycle, press the START pad once and close the door. Cancel To cancel a cycle at anytime, open the door and press the START/CANCEL pad until the 1 min drain feature is initiated. Close the door and the drain cycle will begin. You will hear a tone for the start and completion of the drain cycle. When the door is opened, the last cycle selected will be displayed. If desired, a new cycle can now be selected by pressing START/CANCEL pad and upon closing the door the cycle will begin.