Electrolux EI27BS16JB Complete Owner's Guide (English) - Page 24

Changing the Water and Air Filters

Page 24 highlights

24 Changing the Water and Air Filters Your refrigerator is equipped with separate water and air filtering systems. The water filter system filters all the water used to produce ice. The air filter removes odors and impurities from the refrigerator compartment. NOTE It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1 Push the filter release button above the cartridge to disconnect it. The control panel includes controls to monitor the status of your water and air filters. See the Controls section for more information. About your advanced water filter The PureAdvantageTM NGFC-2000 filter system is tested and certified by NSF International to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. • Rated Capacity - 240 gallons • Rated service flow - .5 gallons per minute • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch • Operating Temp.: Min. 33°F, Max. 100°F Push Water Filter Button 2 Slide the old water filter cartridge straight out of the housing and discard it. 3 Unpack the new filter cartridge and remove the two (2) protective caps covering the inlet and exit of the filter. Slide the filter gently into the housing until it stops against the snap-in connector at the back of the housing. Water filter The water filter is located at the lower left side of the fresh food compartment. Replacing your PureAdvantageTM water filter In general, you should change the water filter every six (6) months to ensure the highest possible water quality. The Water Filter Status light on the Touch Panel prompts you to replace the filter after the 6 month time period has elasped. The water filter status light on this model is not performance tested or certified by NSF. If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

24
Changing the Water and Air Filters
Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all the
water used to produce ice. The air filter removes odors
and impurities from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
About your advanced water filter
The
PureAdvantage
TM
NGFC-2000 filter
system is tested and certified
by NSF
International to NSF/ANSI Standards
42 and 53 for the reduction of claims
specified on the performance data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
Rated Capacity - 240 gallons
Rated service flow - .5 gallons per minute
Maximum Rated Pressure - 100 pounds per
square inch
Recommended Minimum Operating Pressure:
30 pounds per square inch
Operating Temp.: Min. 33°F, Max. 100°F
Water filter
The water filter is located at the lower left side of the
fresh food compartment.
Replacing your
PureAdvantage
TM
water
filter
In general, you should change the water filter every six
(6) months to ensure the highest possible water quality.
The
Water
Filter Status
light on the Touch Panel
prompts you to replace the filter after the 6 month time
period has elasped. The water filter status light on this
model is not performance tested or certified by NSF.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1
Push the filter release button above the cartridge
to disconnect it.
2
Slide the old water filter cartridge straight out of
the housing and discard it.
3
Unpack the new filter cartridge and remove the
two (2) protective caps covering the inlet and exit
of the filter.
Slide the filter gently into the housing
until it stops against the snap-in connector at the
back of the housing.