Electrolux EI27EW35JS Product Specifications Sheet (English) - Page 5

27" Combination Installation - Built-In Microwave/Single Wall Oven For detailed product dimensions and installation specifications, refer to model-specific product page and installation guide on web 27" Built-In Microwave Cutout For model: EI24MO45I (with 27" Trim Kit) 27" Electric Single Wall Oven Cutout For models: EW27EW55G EI27EW35J 16 1/4" min. 163/8" max. 2" (visible gap)* 27 1/4" min. 27 5/8" max. * Minimum 2 7/8" clearance required from bottom of Built-In Microwave cutout to top edge of Wall Oven's faceplate, leaving a 2" visible gap between both product faceplates. ** Critical dimension - MUST be applied † For cutout height between 27 5/8" and 28 1/4" add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven's 1"-high bottom trim will hide shims at bottom. (Optional 3"-high bottom trim available for cutout height between 28 1/4" and 30".) 31" suggested distance 4 1/2" min. required 24" min. 27 1/8" min. 25 1/4" min. 25 3/8" max. 24 7/8" min. 25 1/4" max. 2"-wide wood spacers (if needed)† Trim Kit - 7/8" faceplate overlap 23 1/2" min.** (critical dimension) Electrical junction box location 2" min. 120V/60 Hz grounded electrical MUST be located within shaded area Full plywood base required to support 100 lbs. 4"x 4" opening to route armored cable 3" Full base required to support 150 lbs. 27" Combination Installation Specifications • Always consult local and national electric codes. (Refer to product-specific electrical specifications on this page.) • Minimum 23-1/2" deep cutout dimension is critical for proper combination installation, to ensure that each built-in product's faceplate will fit flush against cabinet front. • Bases must be level and cabinet front must be square. • Minimum 4-1/2" required distance from bottom of Wall Oven cutout to floor, 31" suggested. • Respect critical dimensions as noted for proper installation of built-In products. • Minimum 21" clearance needed for Wall Oven door depth when open. 27" Built-In Microwave Specifications • Product Weight - 48 Lbs. • Voltage Rating - 120V / 60 Hz / 15 or 20 Amps • Connected Load (kW Rating) @ 120 Volts = 1.5 kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.) • Amps @ 120 Volts = 13 Amps • Full oven base of solid plywood or similar material required, capable of supporting 100 Lbs. • Minimum 2-7/8" clearance required from bottom of Built-In Microwave cutout to top edge of Wall Oven's faceplate, leaving a 2" visible gap between both product faceplates. 27" Electric Single Wall Oven Specifications • Product Weight - 150 Lbs. • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • Connected Load (kW Rating) @ 240 / 208 Volts = 3.4 / 2.6 kW • Amps @ 240 / 208 Volts = 14.2 / 12.6 Amps • Full oven base of solid plywood or similar material required, capable of supporting 150 Lbs. • To adapt oven to fit cutout height between 27-5/8" and 28-1/4", add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven's 1"-high bottom trim will hide shims at bottom. (Standard 1"- High Bottom Trim included.) • To adapt oven to fit cutout height between 28-1/4" and 30", optional 3"- High Bottom Trim available. Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxappliances.com for detailed instructions. Electrolux Major Appliances, N.A. USA • 250 Bobby Jones Expressway • Augusta, GA 30907 • 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca MOSS_EW 27INST EL 01/10 © 2010 Electrolux Major Appliances, NA High standards of quality at Electrolux Home Products, Inc. mean we are constantly working to improve our products. We reserve the right to change specifications or discontinue models without notice. Printed in the U.S.A.