Electrolux EI28BS51IB Complete Owner's Guide (English) - Page 24
Changing the Water and Air Filters
UPC - 012505697579
View all Electrolux EI28BS51IB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
24 Changing the Water and Air Filters Your refrigerator is equipped with separate water and air filtering systems. The water filter system filters all the water used to produce ice. The air filter removes odors and impurities from the refrigerator compartment. NOTE It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1 Push the filter release button above the cartridge to disconnect it. The control panel includes controls to monitor the status of your water and air filters. See the Controls section for more information. About your advanced water filter The PureAdvantageTM NGFC-2000 filter system is tested and certified by NSF International to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. • Rated Capacity - 240 gallons • Rated service flow - .5 gallons per minute • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch • Operating Temp.: Min. 33°F, Max. 100°F Push Water Filter Button 2 Slide the old water filter cartridge straight out of the housing and discard it. 3 Unpack the new filter cartridge and remove the two (2) protective caps covering the inlet and exit of the filter. Slide the filter gently into the housing until it stops against the snap-in connector at the back of the housing. Water filter The water filter is located at the lower left side of the fresh food compartment. Replacing your PureAdvantageTM water filter In general, you should change the water filter every six (6) months to ensure the highest possible water quality. The Water Filter Status light on the Touch Panel prompts you to replace the filter after the 6 month time period has elasped. The water filter status light on this model is not performance tested or certified by NSF. If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator.