Electrolux EI30EF55GB Use and Care Manual - Page 15
Setting Surface Controls
View all Electrolux EI30EF55GB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Setting Surface Controls 15 How the cooktop works About the ceramic glass cooktop The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element outline on the cooktop. Heat is transferred up through the surface of the cooktop to the cookware. Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and the settings, are all factors that will affect the amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns. About the radiant surface elements The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and consistent heat during the off cycle. For efficient cooking, turn off the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process. Left rear Warmer zone Right rear Left front Right front Your range is equipped with radiant surface burners with different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases. NOTE • Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at the HI setting is normal and can occur if the cookware is too small for the radiant element or if the cookware bottom is not flat (refer to page 14 for using correct cookware on the cooktop). Oven vent location The oven vent is located under the left side of the control panel. When the upper oven is operational, warm air will pass through this vent naturally. The venting is necessary for proper air circulation and provides good baking results in the upper oven. DO NOT BLOCK THIS VENT. oven vent location • Please read the detailed instructions for ceramic glass cooktop cleaning in both the Care and Cleaning and Before You Call sections of this Use and Care Manual.