Electrolux EI33AR80WS Ice Kit Installation Instructions English
Electrolux EI33AR80WS Manual
View all Electrolux EI33AR80WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Electrolux EI33AR80WS manual content summary:
- Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 1
KIT INSTALLATION INSTRUCTIONS TTFLTRICEKIT Models: FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS We recommend an authorized service technician install the Wiring Harness Strain Reliefs Qty: 2 F 305346-00 Wiring Harness Support Clips Qty: 2 Access Cover Access Cover Water Valve 3 Coils - Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 2
Access Cover Removal Required Tools: ¼" nut driver, flat head screw driver CAUTION Wear gloves and use extreme CAUTION when installing the PROTECTIVE rubber trim. The opening may have sharp edges. 1. Remove the vacuum relief cover. 3. Apply the protective rubber trim (D) to the inside edge of - Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 3
the green port of the water valve up to black line mark. 3. Connect the wiring harness (E), to the connector on the refrigerator. 4. Locate wiring harness support clip at top of refrigerator machine compartment (F), and insert wiring harness to secure. E F 3 - Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 4
the connecting harness are not used when this kit is installed for filtered water provided by the paired refrigerator. 1. Disconnect from the refrigerator to the connector for the freezer. Locate wiring harness support clip at top of refrigerator machine compartment (F), and insert wiring harness to - Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 5
Freezer Connections 6. Insert the bottom of the Access Cover into the compressor base and rotate up. Align the access cover by aligning all 8 screw holes, and then reinstall the vacuum relief cover. x8 5 - Electrolux EI33AR80WS | Ice Kit Installation Instructions English - Page 6
in the Use and Care Manual for details on water dispenser operation and purging method). NOTE Test the water before sliding the units back into the cabinet cutout. B C NOTE This installation does not require a water line Y splitter. 2. Attach the 2 adhesive support clips (F) and insert the
SINGLE-DOOR FREEZER FILTERED
ICE KIT INSTALLATION INSTRUCTIONS
TTFLTRICEKIT
P/N:
A23393001
We recommend an authorized service technician install the filtered ice kit.
NOTE
Without a kit you will need a water line splitter or 2 individual water lines to route the home water supply
to the refrigerator and the freezer. The filtered ice kit can only be used for a Single-Door Freezer being
installed next to a Single-Door Refrigerator that contains water connections. This kit will not work on non-
dispenser refrigerator models. Disconnect electrical power prior to servicing this product.
Models:
FPFU19F8WF
FPRU19F8WF
EI33AF80WS
EI33AR80WS
C
240396805
1/8" Wiring Harness
Strain Reliefs
Qty: 2
Filtered Ice Kit Components
A
218976831
¼
" Green Water Line, 16 ft.
Qty: 1
B
240396804
¼
" Green Water Line
Strain Reliefs
Qty: 2
D
E
F
A19408101
19' Wire Harness
Qty: 1
305346-00
Wiring Harness
Support Clips
Qty: 2
A20060201
11" Rubber Trim Access Cover
Qty: 2
Access
Cover
Water Valve
3 Coils
Water Valve
1 Coil
Access
Cover
Rear View
Refrigerator
Rear View
Freezer
ORIGINAL CONFIGURATION