Electrolux EI36HI55KS Complete Owner's Guide (English) - Page 8
Blower Motor Systems Installation
View all Electrolux EI36HI55KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Blower Motor Systems Installation Install Hood Insert Internal Blower Motor The internal blower system can be mounted for top venting.The mounting bracket and spring clip that comes with the blower system will mount to the top panel of the hood insert. Internal Blower System Installation into Hood Insert IMPORTANT: Perform steps 1-10 before mounting the hood insert into the cabinet. NOTE: Mounting hardware is included with the Blower Motor System. 1. Remove grease filters from hood insert. See the "Cleaning" section in the Use and Care Guide. 2. Install the motor support bracket using three 4.2 x 8 mm screws. Screw bracket to the inside top, toward the left side of the hood insert (see step 2 figure). 3. Install motor spring clip using two 4.2 x 8 mm screws. Screw spring clip to the inside top of the hood insert at the proper location for the selected motor system. Slide the mounting tab of the spring clip through the slot in the panel and secure with the screws (see step 3 figure). 4. Install the 6 mm clip nuts to the outside top of the hood insert at the proper location for the selected motor system. • Two 6 mm nuts are required for 600 CFM (single motor) Blower Motor Assembly. Clip nuts into the small square notches located at the left and right end of the square vent opening. • Four 6 mm nuts are required for 1200 CFM (dual motor) Blower Motor Assembly. Clip nuts into the small square notches, located at the left and right ends of the square vent opening. A. 6mm Clip Nut B. Clip nut locations for single motor assembly (2) C. Clip nut locations for dual motor assembly (4) A C C Outside the hood insert Inside the hood insert STEP 2 F* Outside the hood insert Inside the hood insert STEP 3 A B B 5. Install the hood insert blower motor assembly inside the hood insert canopy with the wiring connection to the left for the single motor system and to the front or top for the dual motor system Single Blower Motor Assembly A A.Wiring connection CD E A. 4.2 x 8 mm screws (3) for motor support bracket B. 4.2 x 8 mm screws (2) for motor spring clip C.Motor support bracket D.Motor spring clip (single motor assembly location) E.Motor spring clip (dual motor assembly location) F. Terminal Box * In model EI30HI55KS is located on the right side