Electrolux EI36HI55KS Complete Owner's Guide (Español) - Page 15
Hood Insert Use
View all Electrolux EI36HI55KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
15 Hood Insert Use Hood Insert Use The hood insert is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen. The hood controls are located on the underside of the hood insert. Cleaning Method: • Liquid detergent soap and water, or all-purpose cleaner. • Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Metal Grease Filter: 1. Remove each filter by pulling the spring release handle and then pulling down the filter. A.Spring release handle Light control Operating the light Fan control Turn the light switch (A) to the left 1 position for HIGH. Turn the light switch (A) to the left 2 postions for LOW. To turn the lights OFF, rotate the light switch (A) to the right to the OFF position. Operating the fan The fan has 4 speeds. Rotate the fan switch (B) to the left to turn the fan to the ON position. Continue to rotate the switch to the desired fan speed. To turn the fan OFF, rotate the fan speed (B) switch to the right to the OFF position. WARNING: The internal blower motor of the hood is thermally protected against high temperatures. If the hood insert is not turned on during the cooking process, high temperatures could be present inside the hood and the motor could not work until the temperature is safe. The hood insert should be turned on during cooking operations. Cleaning IMPORTANT: Clean the hood insert and grease filters frequently according to the following instructions. Replace grease filters before operating hood insert. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. 2. Wash metal filters as needed in dishwasher or hot detergent solution. 3. Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track. 4. Push in spring release handle. 5. Push up on metal filter and release handle to latch into place. 6. Repeat steps 1-5 for the other filter. Replacing the Halogen Lamps Turn off the hood insert and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. Replace bulb, using tissue or wearing cotton gloves to handle bulb. If new lamps do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Push up on the lens and turn it counterclockwise. 3. Remove the bulb and replace it with a 120-volt, 50-watt maximum halogen bulb with a GU10 base. Turn it clockwise to lock it into place. 4. Repeat steps 2-3 for the other bulb if needed. 5. Reconnect power.