Electrolux EI48HI55KS Complete Owner's Guide (English) - Page 12
Make Electrical Connections
View all Electrolux EI48HI55KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 Make Electrical Connections 3. Use UL listed wire connectors and connect the black wires (C) together. 4. Use UL listed wire connectors and connect the white wires (D) together. 5. Use UL listed wire connectors and connect the red wires (E) together. 6. Use UL listed wire connectors and connect the blue wires (F) together. 7. Use UL listed wire connectors and connect the gray wires (G) together. Electrical Shock Hazard Electrically ground blower. Connect ground wire to green and yellow ground wire in terminal box. Failure to do so can result in death or electrical shock. to black, white to white, etc.) using UL listed wire connectors. NOTE: Connect the green (or green/yellow) ground wire from the Remote Blower Motor wiring conduit to the green (or bare) ground wire from the home power supply using UL listed wire connectors (refer to "Make Electrical Power Supply Connection to Hood Insert" section). JK C B D E F G H 8. Connect the green (or yellow/green) ground wire to the green/yellow ground wire (H) in the terminal box using UL listed wire connectors. 9. Reinstall the remote blower terminal box cover and screw. 10. Reinstall the front cover of the remote blower housing and secure it with 10 mounting screws. Make Electrical Connection for Inside Hood Insert Between Remote Blower Motor System and Hood Insert 1. With the hood insert mounted (see the "Install Hood Insert" section), locate the wiring cable connector inside the hood insert. 2. Connect the 6-wire connector assembly supplied with the remote blower motor system to the mating cable connector from the hood insert. A. UL listed or CSA approved 1⁄2" (1.3 cm) wiring conduit B. UL listed wire connectors C. Black wires D.White wires E. Red wires A I F. Blue wires G.Gray wires H. Green (or green/yellow) wire I. 6-wire connector assembly J. Home power supply knockout K. Remote Blower Motor knockout Wire Conector Ground Wiring Connections Home Power Supply Hood Insert Remote Blower Motor 7. Go to the "Make Electrical Power Supply Connection to Hood Insert" section. Prepare the Location 3. Locate the terminal box inside the hood insert and install a ½" (1.3 cm) UL listed or CSA approved strain relief. 4. Run the wire ends from the 6-wire connector a sembly through the ½" (1.3 cm) strain relief, leaving enough wire length to make the wiring conections. Tighten the strain relief screws. 5. Connect the wires from the 6-wire connector asembly to the wires from the remote blower system wiring conduit inside the hood insert terminal box. 6. Connect the same color wires to each other (black 1. Disconnect power. 2. Determine which venting method to use: roof or wall exhaust. 3. Select a flat surface for assembling the hood insert. Place covering over that surface. • It is recommended that the vent system be installed before hood is installed. • Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. • Hood insert should be installed a minimum 24" (61 cm) above an electric cooktop surface and 30" (76.2 cm) above a gas cook top surface. The maximum recommended height over both cook tops is 36" (91.44 cm).