Electrolux EIDW5705PS Complete Owner's Guide (English) - Page 7

Operating Instructions 7 STATUS INDICATOR LIGHTS NOTE Lights and Display on top of console will shut off when the door is closed. They will light up when the door is opened and display time remaining will be displaye for several seconds. Then "Cd" will display flashing, informing you to close the door so the cycle can continue. When the SANITIZE option is selected, the SANITIZED light will glow when the SANITIZE cycle is finished and remain on for 30 seconds after the door is opened. If the dishwasher did not properly sanitize the dishes, the light will not come on. This can happen if the cycle is interrupted or if incoming water temperature is below 120oF. The CLEAN light will come on at the end of the cycle. When the door is opened at end of cycle and remain on for 30 seconds after door is opened. PF........ 1H-24H... Cd......... Minutes..... Appears in window when dishwasher is first installed, or when power has been interrupted. HITEMP WASH and NO HEAT DRY indicator lights will also flash. To clear, touch START/CANCEL pad. Error Indications In certain situations which are critical to the machine function and safe operation, the control shall shut down and indicate an error code 'Er', or 'CE' (See Error Codes). Number of delay start hours. Count down are in hours. Close dishwasher door. The status indicator lights will also flash to indicate current cycle status. If one of these codes are displayed contact the Electrolux Customer Care Center at 1-877-4353287. They will be able to provide assistance in troubleshooting the problem and/or locating an authorized service technician, if needed. Number of minutes left in cycle (1-200). NOTE The wash cycle time could suddenly increase or drop several minutes. This means the Smart Sensor has checked the soil level and determined if additional water fills are needed or if water fills can be deleted.